Search results
Results From The WOW.Com Content Network
Steam ejectors with two, three, four, five and six stages may be used to produce vacuums down to 2.5 kPa, 300 Pa, 40 Pa, 4 Pa, and 0.4 Pa, respectively. [ 1 ] Steam ejectors are also suitable for pumping many liquids since if the steam can be easily condensed into the liquid then there is no need to separate the working fluid or manage a mist ...
A surface condenser is a water-cooled shell and tube heat exchanger installed to condense exhaust steam from a steam turbine in thermal power stations. [ 1 ] [ 2 ] [ 3 ] These condensers are heat exchangers which convert steam from its gaseous to its liquid state at a pressure below atmospheric pressure .
The 500gb BarraCuda drives are likely discontinued as of late 2024 due to declining demand for lower capacity hdds. Now the 1tb model is the lowest capacity likely for 2.5 drives as well. 1Tb 3.5 models using CMR technology are ST1000DM010(released 2016) and the newer ST1000DMZ10(2018). All 2.5 models use SMR which can be slower.
A compression ratio of 2 is possible (and sometimes more) but unless the motive steam is at a reasonably high pressure (say, 16 bar g - 250 psig - or more), the motive steam consumption will be in the range of 2 kg per kg of suction vapors. A higher compression ratio means a smaller heat exchanger, and a reduced investment cost.
The steam injector is a common device used for delivering water to steam boilers, especially in steam locomotives. It is a typical application of the injector principle used to deliver cold water to a boiler against its own pressure, using its own live or exhaust steam, replacing any mechanical pump.
Vacuum systems usually consist of gauges, vapor jet and pumps, vapor traps and valves along with other extensional piping. A vessel that is operating under vacuum system may be any of these types such as processing tank, steam simulator, particle accelerator, or any other type of space that has an enclosed chamber to maintain the system in less than atmospheric gas pressure.
AOL
External hard disk drives are usually available as assembled integrated products, but may be also assembled by combining an external enclosure (with USB or other interface) with a separately purchased drive. They are available in 2.5-inch and 3.5-inch sizes; 2.5-inch variants are typically called portable external drives, while 3.5-inch ...