Search results
Results From The WOW.Com Content Network
If the baseline value is small or subtracted out, the knife-edge beam width always corresponds to 60%, in the case of 20/80, or 80%, in the case of 10/90, of the total beam power no matter what the beam profile. On the other hand, the D4σ, 1/e 2, and FWHM widths encompass fractions of power that are beam-shape dependent. Therefore, the 10/90 ...
Antenna measurement techniques refers to the testing of antennas in order to ensure that the antenna meets specifications or simply to characterize it. Typical antenna parameters are gain , bandwidth , radiation pattern , beamwidth , polarization , impedance ; These are imperative communicative means.
A high-gain antenna (HGA) is a directional antenna with a focused, narrow beam width, permitting more precise targeting of the radio signals. [1] Most commonly referred to during space missions , [ 2 ] these antennas are also in use all over Earth , most successfully in flat, open areas where there are no mountains to disrupt radiowaves.
The half-power point is the angle off boresight at which the antenna gain first falls to half power (approximately −3 dB) [a] from the peak. The angle between the −3 dB points is known as the half-power beam width (or simply beam width). [4] Beamwidth is usually but not always expressed in degrees and for the horizontal plane.
The antenna gain, or power gain of an antenna is defined as the ratio of the intensity (power per unit surface area) radiated by the antenna in the direction of its maximum output, at an arbitrary distance, divided by the intensity radiated at the same distance by a hypothetical isotropic antenna which radiates equal power in all directions.
Antennas can be classified in various ways, and various writers organize the different aspects of antennas with different priorities, depending on whether their text is most focused on specific frequency bands; or antenna size, construction, and placement feasibility; or explicating principles of radio theory and engineering that underlie ...
A typical radar antenna commonly has a beam width of a few degrees. While this is adequate for locating the target in an early warning role, it is not nearly accurate enough for gun laying, which demands accuracies on the order of 0.1 degrees. It is possible to improve the beam width through the use of larger antennas, but this is often ...
Phase-comparison monopulse is a technique used in radio frequency (RF) applications such as radar and direction finding to accurately estimate the direction of arrival of a signal from the phase difference of the signal measured on two (or more) separated antennas [1] or more typically from displaced phase centers of an array antenna.