When.com Web Search

  1. Ads

    related to: metric bolt torque value chart flange bolt up

Search results

  1. Results From The WOW.Com Content Network
  2. Width across flats - Wikipedia

    en.wikipedia.org/wiki/Width_across_flats

    The two systems are in general not compatible, which can result in rounding of nuts and bolts (i.e. using a 13 mm (0.51 in) spanner in place of a 1 ⁄ 2 inch (12.70 mm)). A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ...

  3. ISO 898 - Wikipedia

    en.wikipedia.org/wiki/ISO_898

    This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1. Bolts, screws and studs with specified property classes – Coarse thread and fine pitch thread [2] 2. Nuts with specified proof load values – Coarse ...

  4. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

  5. Screw - Wikipedia

    en.wikipedia.org/wiki/Screw

    The most commonly used pitch value for each diameter is the coarse pitch. For some diameters, one or two additional fine pitch variants are also specified, for special applications such as threads in thin-walled pipes. ISO metric screw threads are designated by the letter M followed by the major diameter of the thread in millimetres (e.g. M8).

  6. Bolted joint - Wikipedia

    en.wikipedia.org/wiki/Bolted_joint

    The applied torque causes the bolt to "climb" the thread causing a tensioning of the bolt and an equivalent compression in the components being fastened by the bolt. The preload developed in a bolt is due to the applied torque and is a function of the bolt diameter, the geometry of the threads, and the coefficients of friction that exist in the ...

  7. ASTM A325 - Wikipedia

    en.wikipedia.org/wiki/ASTM_A325

    ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]