Search results
Results From The WOW.Com Content Network
The technique is commonly used in manufacture of high-pressure pump cylinders, warship and gun barrels, and fuel injection systems for diesel engines. Due to work-hardening process it also enhances wear life of the barrel marginally. While autofrettage will induce some work hardening, that is not the primary mechanism of strengthening.
By creating a pressure differential in the barrel after the shell leaves, the bore evacuator causes most of the propellant gases and combustion residues to exit via the muzzle. Thus, when the breech opens for reloading, those gases and residues do not escape into the crew compartment and pose a hazard to the gun crew. [1]
Burning powder gases melt part of the bore each time a gun is fired. This melted metal is oxidized or blown out of the muzzle until the barrel is eroded to the extent shell dispersion becomes unacceptable. After firing several hundred shells, a gun may be reconditioned by boring out the interior and inserting a new liner as the interior cylinder.
Gun laying is a set of actions to align the axis of a gun barrel so that it points in the required direction. This alignment is in the horizontal and vertical planes. A gun is "traversed" (rotated in a horizontal plane) to align it with the target, and "elevated" (moved in the vertical plane) to
A female worker boring out the barrel of a Lee-Enfield rifle during WWI. Gun barrels are usually made of some type of metal or metal alloy.However, during the late Tang dynasty, Chinese inventors discovered gunpowder, and used bamboo, which has a strong, naturally tubular stalk and is cheaper to obtain and process, as the first barrels in gunpowder projectile weapons such as fire lances. [2]
Barrel nut: A firearm component used on barrels. On handguards, a barrel nut may refer to the component that holds the handguards to the barrel. On machine guns, a barrel nut is a screw on component at the rear of the barrel that has locking lugs and a notch for quick barrel change and helps install it in the trunnion.
Then, the needle gun is used to remove rust, loose scale, and paint, leaving bare metal. [5] It is used most effectively by holding it at a 45° angle to the work surface. [5] It is recommended that an area no larger than 6 to 8 inches (150 to 200 mm) be cleared at once. [5] Two to three passes over an area is generally sufficient to clean it. [5]
Animation of the Vickers muzzle booster operation, showing the expanding gases pushing the barrel to the rear relative to the cooling jacket. A Vickers-type muzzle (or recoil) booster, the "typical" type, consists of two parts: a flared "cup" on the muzzle of the barrel, and a perforated tube around the end of the muzzle, attached to the main body of the weapon.