When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. Central heating - Wikipedia

   en.wikipedia.org/wiki/Central_heating

   Hydronic radiant floor heating systems use a boiler or district heating to heat water and a pump to circulate the hot water in plastic pipes installed in a concrete slab. The pipes, embedded in the floor, carry heated water that conducts warmth to the surface of the floor, where it broadcasts heat energy to the room above.

3. Builder's Old Measurement - Wikipedia

   en.wikipedia.org/wiki/Builder's_Old_Measurement

   The Builder's Old Measurement formula remained in effect until the advent of steam propulsion. Steamships required a different method of estimating tonnage, because the ratio of length to beam was larger and a significant volume of internal space was used for boilers and machinery. In 1849, the Moorsom System was created in the United Kingdom ...

4. Forced-air gas - Wikipedia

   en.wikipedia.org/wiki/Forced-air_gas

   Each room has an outlet from the duct system, often mounted in the floor or low on the wall – some rooms will also have an opening into the cold air return duct. Depending on the age of the system, forced-air gas furnaces use either a pilot light or a solid-state ignition system (spark or hot surface ignition) to light the natural gas burner. [3]

5. Balance point temperature - Wikipedia

   en.wikipedia.org/wiki/Balance_point_temperature

   The building balance point temperature is the outdoor air temperature when the heat gains of the building are equal to the heat losses. [1] Internal heat sources due to electric lighting, mechanical equipment, body heat, and solar radiation may offset the need for additional heating although the outdoor temperature may be below the thermostat set-point temperature.

6. Furnace (central heating) - Wikipedia

   en.wikipedia.org/wiki/Furnace_(central_heating)

   By comparison, most modern "warm air" furnaces typically use a fan to circulate air to the rooms of house and pull cooler air back to the furnace for reheating; this is called forced-air heat. Because the fan easily overcomes the resistance of the ductwork, the arrangement of ducts can be far more flexible than the octopus of old. In American ...

7. Mechanical floor - Wikipedia

   en.wikipedia.org/wiki/Mechanical_floor

   Mechanical floors are generally counted in the building's floor numbering (this is required by some building codes) but are accessed only by service elevators. Some zoning regulations exclude mechanical floors from a building's maximum area calculation, permitting a significant increase in building sizes; this is the case in New York City. [1]