Search results
Results From The WOW.Com Content Network
The big-block engines initially used a forged crankshaft with a stroke of 3.975" for the 1965-1967 425 and 400 CID versions; starting in 1968, both the 400 cu in (6.6 L) and the 455 cu in (7.5 L) big blocks used a stroke of 4.25 in (108 mm), with crankshaft material changed to cast iron except in a few rare cases.
A crank sensor (CKP) [1] [2] [3] is an electronic device used in an internal combustion engine, both petrol and diesel, to monitor the position or rotational speed of the crankshaft. This information is used by engine management systems to control the fuel injection or the ignition system timing and other engine parameters.
A four-stroke (also four-cycle) engine is an internal combustion (IC) engine in which the piston completes four separate strokes while turning the crankshaft. A stroke refers to the full travel of the piston along the cylinder, in either direction. The four separate strokes are termed: Intake: Also known as induction or suction. This stroke of ...
The reciprocating motion of a non-offset piston connected to a rotating crank through a connecting rod (as would be found in internal combustion engines) can be expressed by equations of motion.
The induction stroke is the first phase in a four-stroke (e.g. Otto cycle or Diesel cycle) engine.It involves the downward movement of the piston, creating a partial vacuum that draws an air-fuel mixture (or air alone, in the case of a direct injection engine) into the combustion chamber.
Crankshaft, pistons and connecting rods for a typical internal combustion engine Marine engine crankshafts from 1942. The crankshaft is located within the engine block and held in place via main bearings which allow the crankshaft to rotate within the block. [3] The up-down motion of each piston is transferred to the crankshaft via connecting ...
The small stroke change of 0.03 in (0.76 mm) was accomplished by moving the piston pin and changing the crankshaft stroke; the rod length did not change. The deck height of the AMC six-cylinder block was increased by 1 ⁄ 8 in (3.2 mm) (half the rod length difference) in 1971 to allow for the longer stroke required for the 258.
A "twingle" is a four-stroke twin-cylinder engine with an altered firing order designed to give power pulses similar to a single-cylinder four-stroke engine. Inline twins with a 360° crankpin offset or flat-twins can be easily converted into twingles by firing both of the cylinders at the same time and installing a camshaft or camshafts that ...