Ads
related to: lead bullet sizer dies walmartwalmart.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
Due to the necessity of seating heavier longer bullets more deeply into the powder column due to the short design and maximum overall length of the .325 WSM cartridge, velocity drops off as bullet weight increases. This is particularly evident with mono-metal bullets such as Nosler's E-Tip bullets, and the Barnes X bullets.
In 1963, Elmer Keith and Bill Jordan, with some help from Skeeter Skelton, petitioned Smith & Wesson, Remington, and Norma to produce a pistol and ammunition in .41 caliber which would fall between the extant .357 Magnum and .44 Magnum cartridges in ballistic performance, and at the same time address perceived shortcomings with those loads. [3]
The streamlined bullet was based on the 7.5×55mm Swiss GP11 projectiles and slightly longer and heavier than the Mk VII bullet at 175 gr (11.34 g), the primary difference was the addition of a boat tail at the end of the bullet and using 37 to 41 gr (2.40 to 2.66 g) of nitrocellulose smokeless powder as propellant in the case of the Mk VIIIz ...
The .38-44 revolvers were made by using a .44 Special size gun with the barrel bored to accept .357-caliber bullets (the true bullet diameter of the .38 Special) and the cylinder bored to accept .3801–.3809-inch-diameter (9.65–9.67 mm) cartridges (where the name "38 Special" originated). Since the frame, cylinder, and barrel were much ...
disassembled .32-20 Winchester cartridge with 100 grain lead bullet. The .32-20 Winchester / 7.94x33mmR, also known as .32 WCF (Winchester center fire), was the first small-game lever-action intermediate cartridge that Winchester produced. [4] It was initially introduced as a black-powder cartridge in 1882 for small-game, varmint hunting, and deer.
The last brass case length was 1.050 to 1.100" long and was created exclusively for hand loaders so that both heel-base and hollow-base bullets could be used interchangeably (note that cartridges made from the longest brass cases and heel-base bullets are too long to fit most .41 Long Colt revolvers).
While modern firearms are generally referred to by the name of the cartridge the gun is chambered for, they are still categorized together based on bore diameter. [citation needed] For example, a firearm might be described as a "30 caliber rifle", which could accommodate any of a wide range of cartridges using a roughly 0.30 inches (7.6 mm) projectile; or as a "22 rimfire", referring to any ...
The .577 Snider cartridge was a British black powder metallic centrefire cartridge, which fired a 0.577-inch (14.7 mm), 480-grain (31 g) lead projectile, primarily used in the Snider–Enfield rifle. Early .577 Snider cartridges were made from a composite design using paper and brass foil with a stamped metallic base and primer, much like the ...