Search results
Results From The WOW.Com Content Network
computes the difference in seconds between two time_t values time: returns the current time of the system as a time_t value, number of seconds, (which is usually time since an epoch, typically the Unix epoch). The value of the epoch is operating system dependent; 1900 and 1970 are often used. See RFC 868. clock
[2] In C++, the C++20 revision adds the spaceship operator <=>, which returns a value that encodes whether the 2 values are equal, less, greater, or unordered and can return different types depending on the strictness of the comparison. [3] The name's origin is due to it reminding Randal L. Schwartz of the spaceship in an HP BASIC Star Trek ...
A general solution to this is to use a double-length CAS (DCAS). E.g., on a 32-bit system, a 64-bit CAS can be used. The second half is used to hold a counter. The compare part of the operation compares the previously read value of the pointer and the counter, with the current pointer and counter. If they match, the swap occurs - the new value ...
Double compare-and-swap (DCAS or CAS2) is an atomic primitive proposed to support certain concurrent programming techniques. DCAS takes two not necessarily contiguous memory locations and writes new values into them only if they match pre-supplied "expected" values; as such, it is an extension of the much more popular compare-and-swap (CAS ...
When there is a tie, the floating-point number whose last stored digit is even (also, the last digit, in binary form, is equal to 0) is used. For IEEE standard where the base is , this means when there is a tie it is rounded so that the last digit is equal to .
The register width of a processor determines the range of values that can be represented in its registers. Though the vast majority of computers can perform multiple-precision arithmetic on operands in memory, allowing numbers to be arbitrarily long and overflow to be avoided, the register width limits the sizes of numbers that can be operated on (e.g., added or subtracted) using a single ...
In C and C++, even if two pointers compare as equal that doesn't mean they are equivalent. In these languages and LLVM , the rule is interpreted to mean that "just because two pointers point to the same address, does not mean they are equal in the sense that they can be used interchangeably", the difference between the pointers referred to as ...
FLT_MAX_10_EXP, DBL_MAX_10_EXP, LDBL_MAX_10_EXP – maximum positive integer such that 10 raised to that power is a normalized float, double, long double, respectively; DECIMAL_DIG (C99) – minimum number of decimal digits such that any number of the widest supported floating-point type can be represented in decimal with a precision of DECIMAL ...