When.com Web Search

  1. Ads

    related to: 2.5 inch rigid conduit outside diameter 3 4 emt

Search results

  1. Results From The WOW.Com Content Network
  2. Electrical conduit - Wikipedia

    en.wikipedia.org/wiki/Electrical_conduit

    An electrical conduit is a tube used to protect and route electrical wiring in a building or structure. Electrical conduit may be made of metal, plastic, fiber, or fired clay. Most conduit is rigid, but flexible conduit is used for some purposes. Conduit is generally installed by electricians at the site of installation of electrical equipment.

  3. Copper tubing - Wikipedia

    en.wikipedia.org/wiki/Copper_tubing

    While pipe sizes in Australia are inch-based, they are classified by outside rather than inside diameter (e.g., a nominal 34 inch copper pipe in Australia has measured diameters of 0.750 inches outside and 0.638 inches inside, whereas a nominal 34 inch copper pipe in the U.S. and Canada has measured diameters of 0.875 inch outside and ...

  4. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  5. IP code - Wikipedia

    en.wikipedia.org/wiki/IP_Code

    IP65 touchscreen display IP65 LED lamp. The IP code or ingress protection code indicates how well a device is protected against water and dust. It is defined by the International Electrotechnical Commission (IEC) under the international standard IEC 60529 [1] which classifies and provides a guideline to the degree of protection provided by mechanical casings and electrical enclosures against ...

  6. National pipe thread - Wikipedia

    en.wikipedia.org/wiki/National_pipe_thread

    The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (3 ... length L 4 [6] Actual outside diameter D Tap drill; ... 2 + 5 ⁄ 8: 66.6750 3 ...

  7. Pipe (fluid conveyance) - Wikipedia

    en.wikipedia.org/wiki/Pipe_(fluid_conveyance)

    Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings. The wall thickness on modern copper is usually thinner than 1 ⁄ 16-inch (1.6 mm), so the internal diameter is only "nominal" rather than a controlling dimension. [13]