Search results
Results From The WOW.Com Content Network
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
The 1/e 2 width is equal to the distance between the two points on the marginal distribution that are 1/e 2 = 0.135 times the maximum value. In many cases, it makes more sense to take the distance between points where the intensity falls to 1/e 2 = 0.135 times the maximum value.
Beam – A measure of the width of the ship. There are two types: Beam, Overall (BOA), commonly referred to simply as Beam – The overall width of the ship measured at the widest point of the nominal waterline. Beam on Centerline (BOC) – Used for multihull vessels. The BOC for vessels is measured as follows: For a catamaran: the ...
Example of true position geometric control defined by basic dimensions and datum features. Geometric dimensioning and tolerancing (GD&T) is a system for defining and communicating engineering tolerances via a symbolic language on engineering drawings and computer-generated 3D models that describes a physical object's nominal geometry and the permissible variation thereof.
Basic size The nominal diameter of the shaft (or bolt) and the hole. This is, in general, the same for both components. Lower deviation The difference between the minimum possible component size and the basic size. Upper deviation The difference between the maximum possible component size and the basic size. Fundamental deviation
For a part dimensioned at 10 mm, IT14 allows for up to 0.36 mm of variation in size. As the IT grade number increases, the tolerances increase; similarly, for larger nominal sizes, the standard tolerances increase. For a part dimensioned at 100 mm, IT14 allows for up to 0.87 mm of variation in size.
To take a common example, 195/55R16 would mean that the nominal width of the tire is approximately 195 mm at the widest point, the height of the side-wall of the tire is 55% of the width (107 mm in this example) and that the tire fits 16-inch-diameter (410 mm) rims. The code gives a direct calculation of the theoretical diameter of the tire.
A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...