Ads
related to: flat face and raised flanges for 2 foot wood
Search results
Results From The WOW.Com Content Network
Sizes vary according to the I-joist's intended load and span. Depths can range from 9 + 1 ⁄ 4 to 24 inches (230–610 mm) and reach up to 80 feet (24 m) in length, although 40 to 42 feet (12–13 m) is more common. The intended use for an I-joist is for floor and roof joists, wall studs, and roof rafters in both residential and commercial ...
Tongue and groove is a method of fitting similar objects together, edge to edge, used mainly with wood, in flooring, parquetry, panelling, and similar constructions. Tongue and groove joints allow two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue and groove boards were also used ...
The panels are usually either flat or raised. A flat panel has its visible face flush with the front of the groove in the frame. This gives the panel an inset appearance. This style of panel is commonly made from man-made materials such as MDF or plywood but may also be made from solid wood or tongue and groove planks. Panels made from MDF will ...
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
1. A small band, either raised or sunken and usually square, used to separate mouldings. [45] 2. The raised edge between two flutes on a column or pilaster, if that edge is flat. [46] Finial An element marking the top or end of some object — such as a dome, tower, or gable — often formed to be a decorative feature. Small finials may also be ...
Flitch beam. A flitch beam (or flitched beam) is a compound beam used in the construction of houses, decks, and other primarily wood-frame structures. Typically, the flitch beam is made up of a vertical steel plate sandwiched between two wood beams, the three layers being held together with bolts. In that common form it is sometimes referenced ...
Non-metallic gaskets are used with flat- or raised-face flanges. Spiral-wound gaskets are used with raised-face flanges, and ring-joint gaskets are used with ring-type joint (RTJ) flanges. Stress develops between an RTJ gasket and the flange groove when the gasket is bolted to a flange, leading to plastic deformation of the gasket. [4]
Chamfer. A chamfer (/ ˈʃæmfər / SHAM-fər or / ˈtʃæmfər / CHAM-fər) is a transitional edge between two faces of an object. Sometimes defined as a form of bevel, it is often created at a 45° angle between two adjoining right-angled faces. Chamfers are frequently used in machining, carpentry, furniture, concrete formwork, mirrors, and ...