When.com Web Search

Search results

  1. Results From The WOW.Com Content Network
  2. Transverse abdominis plane block - Wikipedia

    en.wikipedia.org/wiki/Transverse_abdominis_plane...

    A transverse abdominis plane block, also called TAP block, is a regional technique to provide analgesia after lower abdominal wall operations. The techniques was first introduced by Rafi [ 1 ] in 2001.

  3. Engineering drawing abbreviations and symbols - Wikipedia

    en.wikipedia.org/wiki/Engineering_drawing...

    CAD: computer-aided design, computer-aided drafting; cadmium [plating]: CAGE: Commercial and Government Entity [code]: A CAGE code is a unique identifier to label an entity (that is, a specific government agency or corporation at a specific site) that is a CDA, ODA, or MFR of the part defined by the drawing.

  4. Tap (valve) - Wikipedia

    en.wikipedia.org/wiki/Tap_(valve)

    Tap tails are normally 1 ⁄ 2 " or 12 mm in diameter for sinks and 3 ⁄ 4 " or 19 mm for baths, although continental Europe sometimes uses a 3 ⁄ 8 " (still imperial) size. The same connection method is used for a ballcock. The term tap is widely used to describe the valve used to dispense draft beer from a keg, whether gravity feed or ...

  5. Boundary representation - Wikipedia

    en.wikipedia.org/wiki/Boundary_representation

    Parasolid and ACIS are the basis for many of today's commercial CAD systems. Following Braid's work for solids, a Swedish team led by Professor Torsten Kjellberg, developed the philosophy and methods for working with hybrid models, wire-frames, sheet objects and volumetric models during the early 1980s. In Finland, Martti Mäntylä produced a ...

  6. Tape-out - Wikipedia

    en.wikipedia.org/wiki/Tape-out

    The term tapeout currently is used to describe the creation of the photomask itself from the final approved electronic CAD file. Designers may use this term to refer to the writing of the final file to disk or CD and its subsequent transmission to the semiconductor foundry; however, in current practice the foundry will perform checks and make modifications to the mask design specific to the ...

  7. Wall plan - Wikipedia

    en.wikipedia.org/wiki/Wall_plan

    A wall plan is a drawing which consists of complete details with dimensions (with an accuracy of an inch) about all four sides and ceiling of each and every room in a building. It is drawn with the help of a floor plan as the basic input. The main contents in a Wall Plan are: Electrical points (like Switch Board Position, Light Position, etc.)

  8. Barricade tape - Wikipedia

    en.wikipedia.org/wiki/Barricade_tape

    Barricade tape across a door in Japan. Barricade tape is brightly colored tape (often incorporating a two-tone pattern of alternating yellow-black or red-white stripes or the words "Caution" or "Danger" in prominent lettering) that is used to warn or catch the attention of passersby of an area or situation containing a possible hazard.

  9. Transparency (projection) - Wikipedia

    en.wikipedia.org/wiki/Transparency_(projection)

    Overhead projector in operation, with a transparency being flashed. A transparency, also known variously as a viewfoil or foil (from the French word "feuille" or sheet), or viewgraph, is a thin sheet of transparent flexible material, typically polyester (historically cellulose acetate), onto which figures can be drawn.