Ads
related to: gm ignition coil wiring
Search results
Results From The WOW.Com Content Network
High energy ignition, also known as H.E.I., is an electronic ignition system designed by the Delco-Remy Division of General Motors.It was used on all GM vehicles, at least in the North American market, from 1975 through the mid-1980s.
Older ignition systems with a separate ignition coil use a coil wire between the ignition coil and the distributor. A coil wire is of the same construction as a spark plug wire, but generally shorter and with different terminals. Some distributors have an ignition coil built inside them, eliminating the need for a separate coil wire, such as ...
An ignition coil consists of an iron core surrounded by two coils (windings) made from copper wire.The primary winding has relatively few turns of heavy wire, while the secondary winding consists of thousands of turns of smaller wire and is insulated from the high voltage by enamel on the wires and layers of oiled paper insulation.
breaker points magneto ignition 4 coil, distributor, high voltage 4a, 4b distributor with two separate circuits, high voltage 7 terminal on ballast resistor, to distributor 15 battery+ from ignition switch 16 15a from ballast resistor to coil and starter motor 16 15e battery+ from ignition switch, also when starter motor runs
A typical low-tension coil (reproduction) used in the ignition system of an ignitor-fired engine. A low-tension coil is an electrical device used to create a spark across the points of an ignitor on early-1900s gasoline engines, generally flywheel engines, hit-and-miss engines, and other engines of that era.
This DC current flowed through a wire to an ignition coil mounted outside of the engine. The points sometimes were under the flywheel for two-stroke engines, and commonly on the camshaft for four-stroke engines. This system worked like all Kettering (points/coil) ignition systems: the opening points trigger the collapse of the magnetic field in ...