When.com Web Search

  1. Ads

    related to: 3 4 inside diameter hose

Search results

  1. Results From The WOW.Com Content Network
  2. Garden hose - Wikipedia

    en.wikipedia.org/wiki/Garden_hose

    This fitting is used with 1 ⁄ 2-inch, 5 ⁄ 8-inch, and 34-inch hoses. [4] [5] In other countries, a British Standard Pipe (BSP) thread is used, which is 34 inch (19 mm) and 14 TPI (male part outside diameter is 26.441 mm or 1.04 in). The GHT and BSP standards are not compatible, and attempting to connect a GHT hose to a BSP fitting ...

  3. Preferred metric sizes - Wikipedia

    en.wikipedia.org/wiki/Preferred_metric_sizes

    ISO 1307:2006, Rubber and plastics hosesHose sizes, minimum and maximum inside diameters, and tolerances on cut-to-length hoses specifies nominal diameters for four different types of plastic hoses, including "Type C", which includes the typical garden hose. Each nominal diameter specifies different ID minimum and maximum values.

  4. Fire hose - Wikipedia

    en.wikipedia.org/wiki/Fire_hose

    Attack hose is a fabric-covered, flexible hose used to bring water from the fire pumper to the nozzle. This hose ranges in nominal inside diameter from 1.5 to 3 in (38 to 76 mm) and is designed to operate at pressures up to about 400 psi (2,760 kPa). The standard length is 50 ft (15.24 m). [12] Supply and relay hoses

  5. North American Fire Hose Coupler Incompatibilities - Wikipedia

    en.wikipedia.org/wiki/North_American_Fire_Hose...

    At its annual convention at Dallas, TX, the NFPA formally adopted a standard with 2 + 1 ⁄ 2-inch hose with 7.5 threads per inch as the primary standard, with additional sizes of 3 and 3.5 inches (each with 6 threads per inch) and a 4.5 inch coupling with 4 threads per inch, with the fire hydrant standard specifying one 4.5 inch port and two 2 ...

  6. National pipe thread - Wikipedia

    en.wikipedia.org/wiki/National_pipe_thread

    National pipe straight–hose: ... The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (34 ... is loosely related to the inside ...

  7. Nominal Pipe Size - Wikipedia

    en.wikipedia.org/wiki/Nominal_Pipe_Size

    Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...

  1. Ads

    related to: 3 4 inside diameter hose