Search results
Results From The WOW.Com Content Network
[4] [5] After temporarily being attached to the port side of the Unity module, [6] [7] it was moved to its permanent location on the forward end of the Destiny module on 14 November 2007. [8] Harmony added 70 m 3 (2,500 cu ft) to the station's living volume, an increase of almost 20%, from 420 m 3 (15,000 cu ft) to 490 m 3 (17,000 cu ft).
Three PMAs are attached to the ISS, PMA-1 and PMA-2 were launched in 1998 on STS-88, PMA-3 in late 2000 on STS-92. PMA-1 is used to connect the Zarya control module with Unity node 1, Space Shuttles used PMA-2 and PMA-3 for docking. International Docking Adapter (IDA): [35] Converts APAS-95 to the International Docking System Standard.
The vestibule is about 16 inches (0.4 m) long and 6 feet (1.8 m) across. At least one end of the vestibule is often limited in diameter by a smaller bulkhead penetration. The elements are maneuvered to the berthing-ready position by a Remote Manipulator System (RMS).
Close view of the exterior panels of the Pressurized Module and Logistics Module, during STS-132 A prototype for the Small Fine Arm was tested during the STS-85 space shuttle mission in 1997. [21] Kibō is the largest single ISS module: Pressurized module [22] Length: 11.19 metres (36.7 ft) Diameter: 4.39 metres (14.4 ft)
Gripper: A device for grasping or holding, attached to the free end of the last manipulator link; also called the robot’s hand or end-effector. Payload: The maximum payload is the amount of weight carried by the robot manipulator at reduced speed while maintaining rated precision. Nominal payload is measured at maximum speed while maintaining ...
The Canadarm while deploying a payload from the cargo bay of the Space Shuttle. A robotic arm is a type of mechanical arm, usually programmable, with similar functions to a human arm; the arm may be the sum total of the mechanism or may be part of a more complex robot.
In robotics, a manipulator is a device used to manipulate materials without direct physical contact by the operator. The applications were originally for dealing with radioactive or biohazardous materials, using robotic arms , or they were used in inaccessible places.
3D Manipulations occurs before a selection task (in order to visually identify a 3D selection target) and after a selection has occurred, to manipulate the selected object. 3D Manipulations require 3 DOF for rotations (1 DOF per axis, namely x, y, z) and 3 DOF for translations (1 DOF per axis) and at least 1 additional DOF for uniform zoom (or ...