Ads
related to: 2005 hummer h2 a c compressor not turning on engine
Search results
Results From The WOW.Com Content Network
The Hummer H2 is a full-size off-road sport utility vehicle (SUV) that was marketed by Hummer and built in the AM General facility under contract from General Motors from 2002 until 2009. It is based on a modified GMT820 GM three-quarter-ton pickup truck in the front and a half-ton 1500 frame in the rear.
Comparison of normal and distorted airflow into the compressor section [1] A compressor stall is a local disruption of the airflow in the compressor of a gas turbine or turbocharger. A stall that results in the complete disruption of the airflow through the compressor is referred to as a compressor surge. The severity of the phenomenon ranges ...
Air suspension is a type of vehicle suspension powered by an electric or engine-driven air pump or compressor. This compressor pumps the air into a flexible bellows, usually made from textile-reinforced rubber. Unlike hydropneumatic suspension, which offers many similar features, air suspension does not use pressurized liquid, but pressurized ...
Because the H2 is built to the over-8500-lb GVW, its fuel economy is neither published by the U.S. EPA nor counted toward Corporate Average Fuel Economy. [48] For example, H2 in one engine configuration averages an estimated 14 mpg ‑US (17 L/100 km; 17 mpg ‑imp) on the highway and 10 mpg ‑US (24 L/100 km; 12 mpg ‑imp) in the city. [48]
In most steam engine designs there is a short time at the end of the return stroke of the piston when all the valves are shut and it is compressing any remaining steam. Water can be introduced from the boiler or in a cold engine, steam will condense to water on the cool walls of the cylinders and can potentially hydrolock an engine.
The Hummer H3 is an off-road vehicle that was produced from 2005 to 2010 by General Motors. The smallest model of the Hummer lineup, it was offered as a 5-door SUV or a 4-door pickup truck known as the H3T. Unlike the larger H1 and H2 models, the H3 was not developed by AM General.
Dieseling or engine run-on is a condition that can occur in spark-plug-ignited, gasoline-powered internal combustion engines, whereby the engine keeps running for a short period after being turned off, drawing fuel through the carburetor, into the engine and igniting it without a spark.
The compressor map shows the complete running range, i.e. off-design, of the compressor from ground idle to its highest corrected rotor speed, which for a civil engine may occur at top-of-climb, or, for a military combat engine, at take-off on a cold day. [5] Not shown is the sub-idle performance region needed for analyzing normal ground and in ...