When.com Web Search

  1. Ads

    related to: 1 4 inch brass screws for sale home depot lg refrigerator 27 inch black

Search results

  1. Results From The WOW.Com Content Network
  2. Robertson screw - Wikipedia

    en.wikipedia.org/wiki/Robertson_screw

    A Robertson screw, also known as a square screw [1] or Scrulox, [2] is a type of screw with a square-shaped socket in the screw head and a corresponding square protrusion on the tool. Both the tool and socket have a slight taper .

  3. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    In Japan, the male sizes are often designated as DTC-20, DTC-27, DTC-40 (discontinued) and DTC-45 corresponding to a respective screw head size of 3.2 mm, 4.6 mm, 6.4 mm and 7.7 mm; with the size of the screw measured across the widest portion of the mating part of the head. The most common sizes in use for consumer electronics are DTC-20 and ...

  4. Screw - Wikipedia

    en.wikipedia.org/wiki/Screw

    A machine screw is a small fastener less than 14 inch (6.35 mm) in diameter similar to a bolt, but which usually has a recessed drive type (slotted, Phillips, etc.) on its head to allow turning it with a screwdriver. Machine screws are threaded the entire length of the shank, and are intended to screw into a pre-formed thread in either a ...

  5. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    The number series of machine screws has been extended downward to include #00-90 (0.047 in = 0.060 in − 0.013 in) and #000-120 (0.034 in = 0.060 in − 2 × 0.013 in) screws; [3] however, the main standard for screws smaller than #0 is ANSI/ASME standard B1.10 Unified Miniature Screw Threads. This defines a series of metric screws named after ...

  6. Self-tapping screw - Wikipedia

    en.wikipedia.org/wiki/Self-tapping_screw

    Self-tapping screws have a wide range of tip and thread patterns, and are available with almost any possible screw head design. Common features are the screw thread covering the whole length of the screw from tip to head and a pronounced thread hard enough for the intended substrate, often case-hardened. [1]

  7. ISO metric screw thread - Wikipedia

    en.wikipedia.org/wiki/ISO_metric_screw_thread

    A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

  1. Ad

    related to: 1 4 inch brass screws for sale home depot lg refrigerator 27 inch black