Ads
related to: turnbuckle wire tensioner screwfix
Search results
Results From The WOW.Com Content Network
A turnbuckle, stretching screw or bottlescrew is a device for adjusting the tension or length of ropes, cables, tie rods, and other tensioning systems. It normally consists of two threaded eye bolts , one screwed into each end of a small metal frame, one with a conventional right-hand thread and the other with a left-hand thread.
A safety wire is used to ensure proper security for a fastener. The wire needed is long enough to reach from a fixed location to a hole in the removable fastener, such as a pin — a clevis fastener, sometimes a linchpin or hitch-pin through a clevis yoke for instance — and the wire pulled back upon itself, parallel to its other end, then twisted, a single end inserted through a fastener ...
Chain tensioner on a single-speed bicycle Belt tensioner on a belt-drive bicycle Hydraulic bolt tensioner Hydraulic Puller-tensioner . A tensioner is a device that applies a force to create or maintain tension. The force may be applied parallel to, as in the case of a hydraulic bolt tensioner, or perpendicular to, as in the case of a spring ...
A Gripple wire joiner is a device used to join and tension wire, to terminate and suspend wires and wire ropes, and also to support false ceilings, cable baskets, and similar items. They are manufactured in Sheffield, England by Gripple Ltd. [ 1 ] The name derives from the fact the device both "grips" and "pulls" wire.
Multi-jackbolt tensioners (MJTs), registered under the trademark Superbolt or Supernut, are designed to decrease the torque required to tighten large bolted joints. One of the major problems associated with traditional bolt tightening methods is as the diameter of the bolt increases, the amount of torque required to tighten it increases in the third power of the diameter. [1]
A hydraulic riser tensioner consists of a hydraulic cylinder with sheaves at both sides. The cylinder is connected to a number of high-pressure gas bottles via a medium separator. A wire rope is rigged in the cylinder; one end is connected to the fixed part of the tensioner, the other end is connected to the riser. [1]