Search results
Results From The WOW.Com Content Network
This block is one of three displacements, 302/327/350, that underwent a crankshaft bearing diameter transformation for 1968 when the rod-journal size was increased from the 2 in (50.8 mm) diameter small-journal to a 2.1 in (53.3 mm) large-journal and a main-journal size that was increased from 2.3 in (58.4 mm) to 2.45 in (62.2 mm).
Ceramic mold casting, also known ambiguously as ceramic molding, [1] is a group of metal casting processes that use ceramics as the mold material. It is a combination of plaster mold casting and investment casting. [2] [3] There are two types of ceramic mold casting: the Shaw process and the Unicast process. [4]
Evaporative-pattern casting is a type of casting process that uses a pattern made from a material that will evaporate when the molten metal is poured into the molding cavity. The most common evaporative-pattern material used is polystyrene foam. [1] The two major evaporative-pattern casting processes are: [1] Lost-foam casting; Full-mold casting
Permanent mold casting is a metal casting process that employs reusable molds ("permanent molds"), usually made from metal. The most common process uses gravity to fill the mold. However, gas pressure or a vacuum are also used. A variation on the typical gravity casting process, called slush casting, produces hollow castings.
Centrifugal casting (industrial) Continuous casting; Die casting; Evaporative-pattern casting. Full-mold casting; Lost-foam casting; Investment casting (Lost-wax casting) Countergravity casting [1] Lost-foam casting; Low pressure die casting; Permanent mold casting; Plastic mold casting; Resin casting; Sand casting; Shell molding; Slush casting ...
Like sand casting, plaster mold casting is an expendable mold process, however it can only be used with non-ferrous materials. It is used for castings as small as 30 g (1 oz) to as large as 7–10 kg (15–22 lb). Generally, the form takes less than a week to prepare. Production rates of 1–10 units/hr can be achieved with plaster molds. [1] [2]
A bronze casting showing the sprue and risers. A riser, also known as a feeder, [1] is a reservoir built into a metal casting mold to prevent cavities due to shrinkage.Most metals are less dense as a liquid than as a solid so castings shrink upon cooling, which can leave a void at the last point to solidify.
Wax patterns are used in an alternative casting process called investment casting. A combination of paraffin wax, bees wax and carnauba wax is used for this purpose. In this case the wax "pattern" is melted out from the mould cavity which is normally a rigid plaster like material rather than sand, so the wax "pattern" can only be used once. [5]