Ad
related to: setting amplifier input sensitivity
Search results
Results From The WOW.Com Content Network
Loudness compensation, or simply loudness, is a setting found on some hi-fi equipment that increases the level of the high and low frequencies. [1] This is intended to be used while listening at low-volume levels, to compensate for the fact that as the loudness of audio decreases, the ear's lower sensitivity to extreme high and low frequencies ...
The sensitivity of an electronic device, such as a communications system receiver, or detection device, such as a PIN diode, is the minimum magnitude of input signal required to produce a specified output signal having a specified signal-to-noise ratio, or other specified criteria. In general, it is the signal level required for a particular ...
A negative-feedback amplifier (or feedback amplifier) is an electronic amplifier that subtracts a fraction of its output from its input, so that negative feedback opposes the original signal. [1] The applied negative feedback can improve its performance (gain stability, linearity, frequency response, step response ) and reduces sensitivity to ...
The impedance of a line input is typically around 10 kΩ. When driven by a line output's usual low impedance of 100 to 600 ohms, this forms a "bridging" connection in which most of the voltage generated by the source (the output) is dropped across the load (the input), and minimal current flows due to the load's relatively high impedance.
Charge amplifier for piezoelectric sensors. Practical charge amplifiers usually include additional stages like voltage amplifiers, transducer sensitivity adjustment, high and low pass filters, integrators and level monitoring circuits. The charge signals at the input of a charge amplifier can be as low as some fC (FemtoCoulomb = 10 −15 C). A ...
A minimum detectable signal is a signal at the input of a system whose power allows it to be detected over the background electronic noise of the detector system. It can alternately be defined as a signal that produces a signal-to-noise ratio of a given value m at the output.
The current-feedback operational amplifier (CFOA or CFA) is a type of electronic amplifier whose inverting input is sensitive to current, rather than to voltage as in a conventional voltage-feedback operational amplifier (VFA). The CFA was invented by David Nelson at Comlinear Corporation, and first sold in 1982 as a hybrid amplifier, the CLC103.
Schematic of an AGC used in the analog telephone network; the feedback from output level to gain is effected via a Vactrol resistive opto-isolator.. Automatic gain control (AGC) is a closed-loop feedback regulating circuit in an amplifier or chain of amplifiers, the purpose of which is to maintain a suitable signal amplitude at its output, despite variation of the signal amplitude at the input.