Search results
Results From The WOW.Com Content Network
This page lists codes for keyboard characters, the computer code values for common characters, such as the Unicode or HTML entity codes (see below: Table of HTML values"). There are also key chord combinations, such as keying an en dash ('–') by holding ALT+0150 on the numeric keypad of MS Windows computers.
The post 96 Shortcuts for Accents and Symbols: A Cheat Sheet appeared first on Reader's Digest. ... To use alt key codes for keyboard shortcut symbols you’ll need to have this enabled ...
A numeric character reference refers to a character by its Universal Character Set/Unicode code point, and a character entity reference refers to a character by a predefined name. A numeric character reference uses the format &#nnnn; or &#xhhhh; where nnnn is the code point in decimal form, and hhhh is the code point in hexadecimal form.
For example, Alt+0 247 yields a ÷, corresponding to its code point, but the character produced by Alt+2 47 depends on the OEM code page, such as Code page 437, and may yield a ≈. Also Alt + 0 1 2 8 through Alt + 0 1 5 9 yield the characters assigned in rows 8 and 9 in the CP1252 layout , rather than the C1 control codes that are assigned to ...
The block contains all the letters and control codes of the ASCII encoding. It ranges from U+0000 to U+007F, contains 128 characters and includes the C0 controls , ASCII punctuation and symbols , ASCII digits , both the uppercase and lowercase of the English alphabet and a control character .
Under Windows, the Alt key is pressed and held down while a decimal character code is entered on the numeric keypad; the Alt key is then released and the character appears. The numerical code corresponds to the character’s code point in the Windows 1252 code page, with a leading zero; for example, an en dash (–) is entered using Alt+0150 ...
The tool is usually useful for entering special characters. [1] It can be opened via the command-line interface or Run command dialog using the 'charmap' command.. The "Advanced view" check box can be used to inspect the character sets in a font according to different encodings (), including Unicode code ranges, to locate particular characters by their Unicode code point and to search for ...
The spacing diacritic should be used for a baseline letter with a superscript release, such as [tˢʼ] or [kˣʼ], where the scope of the apostrophe includes the non-superscript letter, but the combining apostrophe U+315 might be used to indicate a weakly articulated ejective consonant like [ᵗ̕] or [ᵏ̕], where the whole consonant is ...