Search results
Results From The WOW.Com Content Network
Tunneling a TCP-encapsulating payload (such as PPP) over a TCP-based connection (such as SSH's port forwarding) is known as "TCP-over-TCP", and doing so can induce a dramatic loss in transmission performance — known as the TCP meltdown problem [6] [7] which is why virtual private network (VPN) software may instead use a protocol simpler than ...
In other words, remote port forwarding lets users connect from the server side of a tunnel, SSH or another, to a remote network service located at the tunnel's client side. To use remote port forwarding, the address of the destination server (on the tunnel's client side) and two port numbers must be known.
HTTP tunneling is used to create a network link between two computers in conditions of restricted network connectivity including firewalls, NATs and ACLs, among other restrictions. The tunnel is created by an intermediary called a proxy server which is usually located in a DMZ .
In computer networking, Layer 2 Tunneling Protocol (L2TP) is a tunneling protocol used to support virtual private networks (VPNs) or as part of the delivery of services by ISPs. It uses encryption ('hiding') only for its own control messages (using an optional pre-shared secret), and does not provide any encryption or confidentiality of content ...
A PPTP tunnel is instantiated by communication to the peer on TCP port 1723. This TCP connection is then used to initiate and manage a GRE tunnel to the same peer. The PPTP GRE packet format is non standard, including a new acknowledgement number field replacing the typical routing field in the GRE header. However, as in a normal GRE connection ...
The use of SSL/TLS over TCP port 443 (by default; port can be changed) allows SSTP to pass through virtually all firewalls and proxy servers except for authenticated web proxies. [1] SSTP servers must be authenticated during the SSL/TLS phase. SSTP clients can optionally be authenticated during the SSL/TLS phase and must be authenticated in the ...
A variant of this split tunneling is called "inverse" split tunneling. By default all datagrams enter the tunnel except those destination IPs explicitly allowed by VPN gateway. The criteria for allowing datagrams to exit the local network interface (outside the tunnel) may vary from vendor to vendor (i.e.: port, service, etc.)
The Point-to-Point Protocol over Ethernet (PPPoE) is a network protocol for encapsulating Point-to-Point Protocol (PPP) frames inside Ethernet frames. It appeared in 1999, in the context of the boom of DSL as the solution for tunneling packets over the DSL connection to the ISP's IP network, and from there to the rest of the Internet.