Ads
related to: sd card connector to computer transfer device for mac address
Search results
Results From The WOW.Com Content Network
MAC addresses are primarily assigned by device manufacturers, and are therefore often referred to as the burned-in address, or as an Ethernet hardware address, hardware address, or physical address. Each address can be stored in the interface hardware, such as its read-only memory , or by a firmware mechanism.
After determining that the SD card supports it, the host device can also command the SD card to switch to a higher transfer speed. Until determining the card's capabilities, the host device should not use a clock speed faster than 400 kHz. SD cards other than SDIO (see below) have a "Default Speed" clock rate of 25 MHz.
The table below shows values for PC memory module types. These modules usually combine multiple chips on one circuit board. SIMM modules connect to the computer via an 8-bit- or 32-bit-wide interface. RIMM modules used by RDRAM are 16-bit- or 32-bit-wide. [49] DIMM modules connect to the computer via a 64-bit-wide interface.
A network interface controller (NIC, also known as a network interface card, [3] network adapter, LAN adapter and physical network interface [4]) is a computer hardware component that connects a computer to a computer network. [5] Early network interface controllers were commonly implemented on expansion cards that plugged into a computer bus.
Originally developed by the Personal Computer Memory Card International Association (), the ExpressCard standard is maintained by the USB Implementers Forum ().The host device supports PCI Express, USB 2.0 (including Hi-Speed), and USB 3.0 (SuperSpeed) [2] (ExpressCard 2.0 only) connectivity through the ExpressCard slot; cards can be designed to use any of these modes.
Internal card readers are usually connected to internal USB 1.1 / 2.0 / 3.x ports The number of compatible memory cards varies from reader to reader and can include more than 20 different types. The number of different memory cards that a multi card reader can accept is expressed as x-in-1, with x being a figure of merit indicating the number ...
An alternative to this is a compound device, in which the host assigns each logical device a distinct address and all logical devices connect to a built-in hub that connects to the physical USB cable. USB endpoints reside on the connected device: the channels to the host are referred to as pipes.
The USB mass storage device class (also known as USB MSC or UMS) is a set of computing communications protocols, specifically a USB Device Class, defined by the USB Implementers Forum that makes a USB device accessible to a host computing device and enables file transfers between the host and the USB device. To a host, the USB device acts as an ...