Search results
Results From The WOW.Com Content Network
Yaw string used in front of the cockpit of an F-14D Tomcat. In flight, pilots are instructed to step on the head of the yaw string; the head is the front of the string, where the string is attached to the aircraft. If the head of the yaw string is to the right of the yaw string tail, then the pilot should apply right rudder pressure.
This is typically controlled by the rudder at the rear of the airplane. Roll (bank) – in which one wing of the airplane moves up and the other moves down. This is typically controlled by ailerons on the wings of the airplane. Coordinated flight requires the pilot to use pitch, roll and yaw control simultaneously. See also flight dynamics.
Normal axis, or yaw axis — an axis drawn from top to bottom, and perpendicular to the other two axes, parallel to the fuselage or frame station.; Transverse axis, lateral axis, or pitch axis — an axis running from the pilot's left to right in piloted aircraft, and parallel to the wings of a winged aircraft, parallel to the buttock line.
Normally to make a turn, the pilot banks left or right by adjusting the ailerons on the wings to increase lift on one wing, and decrease lift on the other. The asymmetric lift causes asymmetric drag, which causes the aircraft to yaw adversely. To correct the yaw, the pilot uses the rudder to perform a coordinated turn.
A Boeing 737 uses an adjustable stabilizer, moved by a jackscrew, to provide the required pitch trim forces. Generic stabilizer illustrated. A horizontal stabilizer is used to maintain the aircraft in longitudinal balance, or trim: [3] it exerts a vertical force at a distance so the summation of pitch moments about the center of gravity is zero. [4]
The cockpit of a Slingsby T-67 Firefly two-seat light airplane.The flight instruments are visible on the left of the instrument panel. Flight instruments are the instruments in the cockpit of an aircraft that provide the pilot with data about the flight situation of that aircraft, such as altitude, airspeed, vertical speed, heading and much more other crucial information in flight.
A spin is more complex, involving intentionally stalling a single wing, causing the plane to descend spiraling around its yaw axis in a corkscrew motion. A hammerhead (also known as a stall turn ) is performed by pulling the aircraft up until it is pointing straight up (much like the beginning of a loop), but the pilot continues to fly straight ...
Many transports, bombers and trainers still used fabric, although the flammable nitrate dope was replaced with butyrate dope instead, which burns less readily. [4] The Mosquito is an example of a fabric-covered plywood aircraft. The Vickers Wellington used fabric over a geodesic airframe which offered good combat damage resistance.