Search results
Results From The WOW.Com Content Network
NOVA presents a dramatic, exclusive film of the first "test-tube" baby born in America, Elizabeth Jordan Carr. NOVA follows the pregnancy from the start, presenting the only view on American TV of the extraordinary medical procedures used to remove and fertilize the egg, and of the historic birth on December 28, 1981, in Norfolk, Virginia .
The success of exploratory manual testing relies heavily on the domain expertise of the tester, because a lack of knowledge will lead to incompleteness in testing. One of the key advantages of an informal approach is to gain an intuitive insight to how it feels to use the application.
The simplest tester is the filament continuity tester, usually with a neon lamp connected in series with the filament/heater and a current limiting resistance fed directly by the mains. There is therefore no need to select the appropriate filament voltage for the particular tube under test, but this equipment will not identify tubes that may be ...
This test is performed under normal conditions at 21 °C (70 °F), but also by simulating cold polar −54 °C (−65 °F) or hot desert 52 °C (126 °F) conditions using special cooling equipment and ovens to cool or heat the ammunition under test to the appropriate levels of humidity and temperatures required.
The United States Naval Test Pilot School (USNTPS), located at Naval Air Station (NAS) Patuxent River in Patuxent River, Maryland, provides instruction to experienced United States Navy, Marine Corps, Army, Air Force, and foreign military experimental test pilots, flight test engineers, and flight test flight officers in the processes and techniques of aircraft and systems testing and evaluation.
In electrical engineering, a dielectric withstand test (also pressure test, high potential test, hipot test, or insulation test) is an electrical safety test performed on a component or product to determine the effectiveness of its insulation. The test may be between mutually insulated sections of a part, or energized parts and ground.
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
A test takes a mere 2 seconds and, using the standard probe D, leaves an indentation of just ~0.5 mm in diameter on steel or steel casting with a Leeb hardness of 600 HLD. By comparison, a Brinell indentation on the same material is ~3 mm (hardness value ~400 HBW 10/3000), with a standard-compliant measuring time of ~15 seconds plus the time ...