Ad
related to: vor radial vs bearing blade torque chart for tires
Search results
Results From The WOW.Com Content Network
Tire forces are divided into three axes: radial, lateral, and tangential (or fore-aft). The radial axis runs from the tire center toward the tread, and is the vertical axis running from the roadway through the tire center toward the vehicle. This axis supports the vehicle's weight. The lateral axis runs sideways across the tread.
Radial force variation or road force variation [1] (RFV) is a property of a tire that affects steering, traction, braking and load support.High values of RFV for a given tire reflect a high level of manufacturing variations in the tire structure that will impart ride disturbances into the vehicle in the vertical direction.
In the tire factory, the tire and wheel are mounted on a balancing machine test wheel, the assembly is rotated at 100 r/min (about 5–7 m/s (18–25 km/h; 11–16 mph) with recent high sensitivity sensors) or higher, 300 r/min (about 25–27 m/s (90–97 km/h; 56–60 mph) with typical low sensitivity sensors), and forces of unbalance are ...
A cross-section of a tire. Number 12 indicates the radial ply. Numbers 14 and 16 are bias plies. A radial tire (more properly, a radial-ply tire) is a particular design of vehicular tire. In this design, the cord plies are arranged at 90 degrees to the direction of travel, or radially (from the center of the tire).
Self aligning torque , slip angle , and camber angle are also shown. Self aligning torque ( SAT ), also known as aligning torque or aligning moment ( Mz , moment about the z direction ), is the torque that a tire creates as it rolls along, which tends to steer it, i.e. rotate it around its vertical axis.
In many applications tapered roller bearings are used in back-to-back pairs so that axial forces can be supported equally in either direction. Pairs of tapered roller bearings are used in car and vehicle wheel bearings where they must cope simultaneously with large vertical (radial) and horizontal (axial) forces.
Starting in 1972 tires were specified by load rating, using a letter code. In practice, a higher load rating tire was also a wider tire. In this system a tire had a letter, optionally followed by "R" for radial tires, followed by the aspect ratio, a dash and the diameter – C78-15 or CR78-15 for bias and radial, respectively. Each diameter of ...
Cornering force is generated by tire slip and is proportional to slip angle at low slip angles. The rate at which cornering force builds up is described by relaxation length. [2] Slip angle describes the deformation of the tire contact patch, and this deflection of the contact patch deforms the tire in a fashion akin to a spring.