Ad
related to: why no output device found dell laptop
Search results
Results From The WOW.Com Content Network
The power supply only provides 12 V voltage output; [13] 5 V, 3.3 V powers, as needed by USB, hard disk drive and other devices, are transformed on the motherboard; and the ATX motherboard connector is reduced from 24-pin to 10-pin. Called ATX12VO, it is not expected to replace current standards but to exist alongside it. [14]
A display device is the most common form of output device which presents output visually on computer screen. The output appears temporarily on the screen and can easily be altered or erased. With all-in-one PCs, notebook computers, hand held PCs and other devices; the term display screen is used for the display device. The display devices are ...
The term can also be used as part of an action; to "perform I/O" is to perform an input or output operation. I/O devices are the pieces of hardware used by a human (or other system) to communicate with a computer. For instance, a keyboard or computer mouse is an input device for a computer, while monitors and printers are output devices.
To allow for voltage drops, the voltage at the host port, hub port, and device are specified to be at least 4.75 V, 4.4 V, and 4.35 V respectively by USB 2.0 for low-power devices, [a] but must be at least 4.75 V at all locations for high-power [b] devices (however, high-power devices are required to operate as a low-powered device so that they ...
Pages in category "Computer output devices" The following 33 pages are in this category, out of 33 total. This list may not reflect recent changes. ...
A simple general-purpose desktop power supply used in electronic labs, with power output connector seen at lower-left and power input connector (not shown) located at the rear Interior of high-end linear power supply with toroidal mains transformer. A power supply is an electrical device that supplies electric power to an electrical load.
The device either accepts the request or rejects it; if accepted, the device sends data or accepts data from the host. If the endpoint is halted, the device responds with a STALL handshake. If there is lack of buffer space or data, it responds with a Not Ready (NRDY) signal to tell the host that it is not able to process the request.
The tablet computer and its associated operating system began with the development of pen computing. [10] Electrical devices with data input and output on a flat information display existed as early as 1888 with the telautograph, [11] which used a sheet of paper as display and a pen attached to electromechanical actuators.