Search results
Results From The WOW.Com Content Network
An atomic force microscope on the left with controlling computer on the right. Atomic force microscopy [1] (AFM) gathers information by "feeling" or "touching" the surface with a mechanical probe. Piezoelectric elements that facilitate tiny but accurate and precise movements on (electronic) command enable precise scanning.
Scheme of the colloidal probe technique for direct force measurements in the sphere-plane and sphere-sphere geometries. The colloidal probe technique is commonly used to measure interaction forces acting between colloidal particles and/or planar surfaces in air or in solution. This technique relies on the use of an atomic force microscope (AFM).
Non-contact atomic force microscopy (nc-AFM), also known as dynamic force microscopy (DFM), is a mode of atomic force microscopy, which itself is a type of scanning probe microscopy. In nc-AFM a sharp probe is moved close (order of Angstroms ) to the surface under study, the probe is then raster scanned across the surface, the image is then ...
Kelvin probe force microscopy (KPFM), also known as surface potential microscopy, is a noncontact variant of atomic force microscopy (AFM). [ 1 ] [ 2 ] [ 3 ] By raster scanning in the x,y plane the work function of the sample can be locally mapped for correlation with sample features.
Topographic (left) and current (right) maps collected with CAFM on a polycrystalline HfO 2 stack. The images show very good spatial correlation. In microscopy, conductive atomic force microscopy (C-AFM) or current sensing atomic force microscopy (CS-AFM) is a mode in atomic force microscopy (AFM) that simultaneously measures the topography of a material and the electric current flow at the ...
Atomic force microscope inside a FTIR spectrometer with the optical interface. The earliest measurements combining AFM with infrared spectroscopy were performed in 1999 by Hammiche et al. at the University of Lancaster in the United Kingdom, [1] in an EPSRC-funded project led by M Reading and H M Pollock.
MFM images of 3.2 Gb and 30 Gb computer hard-drive surfaces. Comparison of Faraday-effect image (left) and MFM image (inset, lower-right) of a magnetic film. Magnetic force microscopy (MFM) is a variety of atomic force microscopy, in which a sharp magnetized tip scans a magnetic sample; the tip-sample magnetic interactions are detected and used to reconstruct the magnetic structure of the ...
This software enables users of atomic force microscopes to easily: build complex band-excitation waveforms, set up the microscope scanning conditions, configure the input and output electronics to generate the waveform as a voltage signal and capture the response of the system, perform analysis on the captured response, and display the results ...