Search results
Results From The WOW.Com Content Network
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks. The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
VLANs operate at the data link layer of the OSI model. Administrators often configure a VLAN to map directly to an IP network, or subnet, which gives the appearance of involving the network layer. Generally, VLANs within the same organization will be assigned different non-overlapping network address ranges. This is not a requirement of VLANs.
This is known as inter-VLAN routing. On layer-3 switches it is accomplished by the creation of layer-3 interfaces (SVIs). Inter VLAN routing, in other words routing between VLANs, can be achieved using SVIs. [1] SVI or VLAN interface, is a virtual routed interface that connects a VLAN on the device to the Layer 3 router engine on the same device.
IEEE 802.1Q, often referred to as Dot1q, is the networking standard that supports virtual local area networking (VLANs) on an IEEE 802.3 Ethernet network. The standard defines a system of VLAN tagging for Ethernet frames and the accompanying procedures to be used by bridges and switches in handling such frames.
A Private VLAN divides a VLAN (Primary) into sub-VLANs (Secondary) while keeping existing IP subnet and layer 3 configuration. A regular VLAN is a single broadcast domain, while private VLAN partitions one broadcast domain into multiple smaller broadcast subdomains. Primary VLAN: Simply the original VLAN. This type of VLAN is used to forward ...
An example of how to configure a simple, three switch MSTP topology wherein a layer-two access switch carries four VLANs and has two uplinks to two distribution switches, can be found here: MSTP Configuration Guide A good configuration view, from the above-mentioned example shall be: S3# show spanning-tree mst
For example, connecting two distinct segments (e.g. VLANs) with a router to a standard layer-2 switch requires passing the frame to the switch (first L2 hop), then to the router (second L2 hop) where the packet inside the frame is routed (L3 hop) and then passed back to the switch (third L2 hop). A layer-3 switch accomplishes the same task ...
Simply do not put any hosts on VLAN 1 (the default VLAN). i.e., assign an access VLAN other than VLAN 1 to every access port Switch (config-if)# switchport access vlan 2; Change the native VLAN on all trunk ports to an unused VLAN ID. Switch (config-if)# switchport trunk native vlan 999; Explicit tagging of the native VLAN on all trunk ports.