When.com Web Search

  1. Ads

    related to: hydraulic cylinder 2 inch bore

Search results

  1. Results From The WOW.Com Content Network
  2. Hydraulic cylinder - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_cylinder

    Small-bore cylinders usually have 4 tie rods, and large bore cylinders may require as many as 16 or 20 tie rods in order to retain the end caps under the tremendous forces produced. Tie rod style cylinders can be completely disassembled for service and repair, and they are not always customizable.

  3. AMC straight-4 engine - Wikipedia

    en.wikipedia.org/wiki/AMC_straight-4_engine

    The 2.5 L I4 head lost two cylinders in its center compared to the original 258 cu in (4.2 L) I6 design. A new cylinder head for the 2.5 L I4 engine featured a double-quench combustion chamber. Its shape provides little space at the front and rear when the piston rises to the top of its compression stroke. [2]

  4. Hydraulic machinery - Wikipedia

    en.wikipedia.org/wiki/Hydraulic_machinery

    Cylinder C1 is one inch in radius, and cylinder C2 is ten inches in radius. If the force exerted on C1 is 10 lbf, the force exerted by C2 is 1000 lbf because C2 is a hundred times larger in area (S = πr²) as C1. The downside to this is that you have to move C1 a hundred inches to move C2 one inch.

  5. Ford Pinto engine - Wikipedia

    en.wikipedia.org/wiki/Ford_Pinto_engine

    The 2.0 litre version was a narrower-bore version of the original 2.3 liter "Lima" four. Bore and stroke are 89.3 and 79.4 mm (3.52 and 3.13 in), respectively, for an overall displacement of 2.0 L; 121.4 cu in (1,990 cc). This engine was installed in the 1983–1988 Ford Rangers and in some Argentinian Ford Taunus. Applications

  6. Telescopic cylinder - Wikipedia

    en.wikipedia.org/wiki/Telescopic_cylinder

    Telescopic cylinders must only be used in machinery as a device for providing force and travel. Side forces and moment loads must be minimized. Telescopic cylinders should not be used to stabilize a structural component. [4] Hydraulic telescopic cylinders are often limited to a maximum hydraulic pressure of 2000-3000 psi.

  7. Holden straight-six motor - Wikipedia

    en.wikipedia.org/wiki/Holden_straight-six_motor

    The Holden straight-six motor is a series of straight-six engines that were produced by General Motors Holden at their Port Melbourne plant between 1948 and 1986. The initial Grey motor was so dubbed because of the colour of the cylinder block, later motors came in the form of a Red, Blue, Black, and the four-cylinder Starfire engine.