Ad
related to: quicksilver throttle control diagram
Search results
Results From The WOW.Com Content Network
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
Quicksilver MX Quicksilver MX II Sprint two seater Quicksilver Sport 2S, showing its struts, in place of wire bracing Quicksilver C The C model was the earliest powered version and consisted of the Quicksilver hang glider, including the weight-shift sling seat, with a McCulloch MAC 101 powerplant of 12 hp (9 kW), a V-belt reduction drive and a 1.7 US gal (6 L) fuel tank.
Thrust levers in a Boeing 747 Classic. The center and rear levers are used during flight, while the forward levers control reverse thrust.. Thrust levers or throttle levers are found in the cockpit of aircraft, and are used by the pilot, copilot, flight engineer, or autopilot to control the thrust output of the aircraft's engines, by controlling the fuel flow to those engines. [1]
Cowl flap position control - Cowl Flaps are opened during high power/low airspeed operations like takeoff to maximize the volume of cooling airflow over the engine's cooling fins. Cylinder head temperature gauge - Indicates the temperature of all cylinder heads or on a single CHT system, the hottest head.
Some engine control units (ECUs) also control the throttle position by electronic throttle control (ETC) or "drive by wire" systems, and if that is done, the position sensor is used in a feedback loop to enable that control. [1] Related to the TPS are accelerator pedal sensors, which often include a wide open throttle (WOT) sensor.
An idle air control actuator or idle air control valve (IAC actuator/valve) is a device commonly used in fuel-injected vehicles to control the engine's idling rotational speed . [1] In carburetted vehicles a similar device known as an idle speed control actuator is used.
Thrust levers of an A320 set to the autothrust position during cruise flight. An autothrottle (automatic throttle, also known as autothrust, A/T or A/THR) is a system that allows a pilot to control the power setting of an aircraft's engines by specifying a desired flight characteristic, rather than manually controlling the fuel flow.
Cockpit controls and instrument panel of a Cessna 182D Skylane. Generally, the primary cockpit flight controls are arranged as follows: [2] A control yoke (also known as a control column), centre stick or side-stick (the latter two also colloquially known as a control or joystick), governs the aircraft's roll and pitch by moving the ailerons (or activating wing warping on some very early ...