When.com Web Search

Search results

1. Results From The WOW.Com Content Network

2. ASTM A325 - Wikipedia

   en.wikipedia.org/wiki/ASTM_A325

   ASTM A325 is an ASTM International standard for heavy hex structural bolts, titled Standard Specification for Structural Bolts, Steel, Heat Treated, 120/105 ksi Minimum Tensile Strength. It defines mechanical properties for bolts that range from 1 ⁄ 2 to 1 + 1 ⁄ 2 inches (13 to 38 mm) in diameter. [1]

3. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   A metric ISO screw thread is designated by the letter M followed by the value of the nominal diameter D (the maximum thread diameter) and the pitch P, both expressed in millimetres and separated by a dash or sometimes the multiplication sign, × (e.g. M8-1.25 or M8×1.25). If the pitch is the normally used "coarse" pitch listed in ISO 261 or ...

4. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Slot screw drives have a single horizontal indentation (the slot) in the fastener head and is driven by a "common blade" or flat-bladed screwdriver.This form was the first type of screw drive to be developed, and, for centuries, it was the simplest and cheapest to make because it can just be sawed or filed.

5. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   A plow bolt is bolt similar to a carriage bolt, except the head is flat or concave, and the underside of the head is a cone designed to fit in a countersunk recess. Plow bolts provide a smooth surface for attaching a plow moldboard to its beam, where a raised head would suffer from soil abrasion. There are many variations, with some not using a ...

6. Thread angle - Wikipedia

   en.wikipedia.org/wiki/Thread_angle

   Metric trapezoidal threads [1] Tr 30° DIN 103 Buttress threads [6] S 45° DIN 2781 German buttress threads [6] S 30° DIN 513 Square threads [1] Sq 0° (parallel) ? Panzergewinde, "steel conduit thread" Pg 80° DIN 40430 British Association (BA) thread: BA 47° 30' = 47.5° BS 93:2008 Löwenherz thread [8] 53° 8' ≈ 53.1° Bodmer thread [9] 50°

7. United States Standard thread - Wikipedia

   en.wikipedia.org/wiki/United_States_Standard_thread

   In 1898, the standard for metric threaded fasteners was established. [5] The metric standard used the same thread geometry as the USS standard but differed in that the dimensions and pitch were based on metric units. In 1906, the A.L.A.M developed what would be the SAE thread standard for threaded fasteners based on the USS standard but with a ...