Ad
related to: flag pole pulley diagram labeled video instructions full size ford bronco rear cargo space
Search results
Results From The WOW.Com Content Network
The Ford Bronco II is a compact sport utility vehicle (SUV) that was manufactured by the American manufacturer Ford.Closely matching the first-generation Ford Bronco in size, the Bronco II was sold for the 1984 to 1990 model years, alongside the third and fourth generations of Ford's full-size Bronco.
As with the 1978–1979 Bronco, the rear axle was first a leaf-sprung Ford 9-inch axle in early models, however Ford transitioned all half ton trucks to their 8.8 rear axle by the end of 1986. [ 18 ] For the first time since 1977, the Bronco came with an inline-six engine as standard; the 4.9L 300 I6 was available solely with a manual transmission.
2.6, 2.8, 2.9, and 2.9 Cosworth. Most of these were RWD car engines. Some had the same Mitsubishi manual transmission as the 2.0/2.3 but had different bellhousings. The 2.3, 2.8, and 2.9 also made it into the Ranger, and Bronco II. 4.0L was produced by Ford Cologne Germany (like the unrelated and the all-new metric Taurus/Sable FWD 3.0 V6).
A flagpole, flagmast, flagstaff, or staff is a pole designed to support a flag. If it is taller than can be easily reached to raise the flag, a cord is used, looping around a pulley at the top of the pole with the ends tied at the bottom. The flag is fixed to one lower end of the cord, and is then raised by pulling on the other end.
Diagram 3 shows three rope parts supporting the load W, which means the tension in the rope is W/3. Thus, the mechanical advantage is three-to-one. By adding a pulley to the fixed block of a gun tackle the direction of the pulling force is reversed though the mechanical advantage remains the same, Diagram 3a. This is an example of the Luff tackle.
A dumb pulley can lift very large masses a short distance. It consists of two fixed pulleys of unequal radii that are attached to each other and rotate together, a single pulley bearing the load, and an endless rope looped around the pulleys. To avoid slippage, the rope is usually replaced by a chain, and the connected pulleys by sprockets.
AOL latest headlines, entertainment, sports, articles for business, health and world news.
An illustration showing how pulleys are used to obtain a mechanical advantage. Using additional pulleys decreases the force required but increases the distance required to raise a load the same amount.