Search results
Results From The WOW.Com Content Network
QAM is used in a variety of communications systems such as Dial-up modems and WiFi. In cable systems, a QAM tuner is linked to the cable in a manner that is equivalent to an ATSC tuner which is required to receive over-the-air (OTA) digital channels broadcast by local television stations when attached to an antenna. Most new HDTV digital ...
A USB digital TV receiver with its antenna. A DTV receiver is a set-top box that permits the reception of digital television.Its components are very similar to a desktop PC. The DTV receiver is a vital link in the chain of television syste
FM channel 200, 87.9 MHz, overlaps TV 6. This is used only by K200AA.; TV 6 analog audio can be heard on FM 87.75 on most broadcast radio receivers as well as on a European TV tuned to channel E4A or channel IC, but at lower volume than wideband FM broadcast stations, because of the lower deviation.
Any converter box converts the digital signal for the current digital sub-channel to an analog signal (at the reduced screen resolution of the analog standard), outputs that signal onto analog channel 3 or 4 (set by the user to avoid any conflict with local over-the-air channels) and sends that signal to the analog tuner on the TV. With a box ...
A "181-channel tuner" receives 125 on cable (1 to 125), plus 10 (126 to 135) more for digital cable ready TVs, plus the 56 (14 to 69) which are not identical in both (2 to 13). Other cable channels, 0, 00 and 1, which along with channels 136-158 are ill-defined and thus rarely used, and often not included in otherwise cable-ready tuners.
ATSC and DVB-T specify the modulation used for over-the-air digital television; by comparison, QAM is the modulation method used for cable. The specifications for a cable-ready television, then, might state that it supports 8VSB (for broadcast TV) and QAM (for cable TV). 8VSB is an 8-level vestigial sideband modulation.
A cable converter box or television converter box is an electronic tuning device that transposes/converts channels from a cable television service to an analog RF signal on a single channel, usually VHF channel 3 or 4, or to a different output for digital televisions such as HDMI.
QAM Mapper: the bit sequence is mapped into a base-band digital sequence of complex symbols. There are 5 allowed modulation modes: 16- QAM , 32-QAM, 64-QAM, 128-QAM, 256-QAM. Base-band shaping: the QAM signal is filtered with a raised-cosine shaped filter, in order to remove mutual signal interference at the receiving side.