Search results
Results From The WOW.Com Content Network
In modern rammed earth buildings, the walls are constructed on top of conventional footings or a reinforced concrete slab base. Contemporary slip formwork in use. The construction of an entire wall begins with a temporary frame, the "formwork", which is usually made of wood or plywood, as a mold for each wall section's desired shape and dimensions.
At one extreme, an earth sheltered dwelling is completely underground, with perhaps an open courtyard to provide air and light. An earth house may be set into a slope, with windows or door openings in one or more of its sides, or the building may be on ground level, but with earth mounded against the walls, and perhaps with an earth roof. [49]
A load-bearing wall or bearing wall is a wall that is an active structural element of a building — that is, it bears the weight of the elements above said wall, resting upon it by conducting its weight to a foundation structure. [1] The materials most often used to construct load-bearing walls in large buildings are concrete, block, or brick.
Also called strip footing, a wall footing is a continuous strip that supports structural and non-structural load-bearing walls. Found directly under the wall, Its width is commonly 2-3 times wider than the wall above it. [3] Detail Section of a strip footing and its wall.
Precast concrete retaining wall A typical cross-section of a slope used in two-dimensional analyzes. Geotechnical engineering, also known as geotechnics, is the branch of civil engineering concerned with the engineering behavior of earth materials. It uses the principles of soil mechanics and rock mechanics to solve its engineering problems.
Mechanically stabilized earth (MSE or reinforced soil) is soil constructed with artificial reinforcing. It can be used for retaining walls , bridge abutments, seawalls , and dikes . [ 1 ] [ 2 ] Although the basic principles of MSE have been used throughout history, MSE was developed in its current form in the 1960s.
When used in permanent works, these walls can be designed to resist vertical loads in addition lateral load from retaining soil. Construction of both methods is the same as for foundation bearing piles. Contiguous walls are constructed with small gaps between adjacent piles. The spacing of the piles can be varied to provide suitable bending ...
A retaining wall is designed to hold in place a mass of earth or the like, such as the edge of a terrace or excavation. The structure is constructed to resist the lateral pressure of soil when there is a desired change in ground elevation that exceeds the angle of repose of the soil.