Search results
Results From The WOW.Com Content Network
[citation needed] Volvo had a light labeled "lambda", lambda sond being another name for oxygen sensor. This was done in order to remind the driver to change the oxygen sensor. Some American-built 1973–1976 Chrysler Corporation vehicles had a similar odometer-triggered reminder: "Check EGR", which was reset after service at a Chrysler dealership.
The 2009–11 Toyota vehicle recalls involved three separate but related recalls of automobiles by the Japanese manufacturer Toyota Motor Corporation, which occurred at the end of 2009 and the start of 2010. Toyota initiated the recalls, the first two with the assistance of the U.S. National Highway Traffic Safety Administration (NHTSA), after ...
A bad crank position sensor can worsen the way the engine idles, or the acceleration behaviour. If the engine is revved up with a bad or faulty sensor, it may cause misfiring, motor vibration or backfires. Acceleration might be hesitant, and abnormal shaking during engine idle might occur. In the worst case, the car may not start.
The heart of the Mitsubishi's MVV system is the linear air–fuel ratio exhaust gas oxygen sensor. Compared with standard oxygen sensors, which essentially are on-off switches set to a single air/fuel ratio, the lean oxygen sensor is more of a measurement device covering the air/fuel ratio range from about 15:1 to 26:1. [19]
If the breath sample isn't provided, or the sample exceeds the ignition interlock's preset blood alcohol level, the device will log the event, warn the driver, and then start up an alarm in accordance to state regulations (e.g., lights flashing, horn honking) until the ignition is turned off, or a clean breath sample has been provided. A common ...
Carbon build-up in the intake manifold will occur when blow-by gases are allowed to permanently contaminate the intake air because of a failing PCV system. [12] Carbon build-up or oil sludge from blow-by gases on intake valves are usually not a problem in port injected engines. This is due to the fact that the fuel hits the intake valves on the ...
The AE85 was available with a carburetor-equipped 3A-U 1,452 cc (1.5 L; 88.6 cu in) inline-four engine, an SOHC (Single overhead cam) two-valve-per-cylinder motor, which at the time was nothing new; the previous fourth generation Toyota Corollas and Sprinters such as the AE70 featured the same engine. Toyota opted to use the older, less ...
The Corolla E90 was the sixth generation of cars sold by Toyota under the Corolla nameplate, introduced in 1987 for the 1988 model year. It was the last generation of Corolla to be classified as a subcompact car and the first to be exclusively front-wheel drive or all-wheel drive ; [ 3 ] the performance option of rear-wheel drive was dropped.