Search results
Results From The WOW.Com Content Network
The DW-link uses anti-squat to eliminate "suspension bob." Squat is defined as the tendency of rear suspension to compress under acceleration. The anti-squat used in the DW-link system is achieved by a minimisation of torque about the centre of mass. The DW-link system has also been designed to minimise pedal feedback caused by suspension travel.
A chain drive and rear derailleur gear change, the most popular system in use today A shaft-drive with crankset and rear gear hub. Bicycle drivetrain systems are used to transmit power on bicycles, tricycles, quadracycles, unicycles, or other human-powered vehicles from the riders to the drive wheels.
Before the introduction of transmission synchronizers in 1927, [2] double clutching was a technique required to prevent damage to an automobile's gearing during shifts. Due to the difficulty and most often unnecessary redundancy involved in the technique, coupled with the advent of synchronized gearing systems, it has largely fallen into disuse in light vehicles.
Toe clips: a metal or plastic cage attached to a pedal. Usually has an adjustment strap. Secures foot to pedal for increased control and more effective transfer of power from foot to drive chain; Top tube: frame member leading from head tube to seat tube; Valve stem or simply valve: port for adding or releasing air from the inner tube.
A typical ETC system consists of three major components: (i) an accelerator pedal module (ideally with two or more independent sensors), (ii) a throttle valve that can be opened and closed by an electric motor (sometimes referred to as an electric or electronic throttle body (ETB)), and (iii) a powertrain or engine control module (PCM or ECM). [4]
A single dwell linkage takes advantage of the behavior of a link with a stationary revolute (hinge) or prismatic (sliding) joint and its interaction with special coupler curves. There are two methods of producing a single-dwell: arc-based and linear-based. An arc-based single dwell linkage uses the approximation of a circular arc.
Multi-link suspension allows the auto designer the ability to incorporate both good ride and good handling in the same vehicle.. In its simplest form, the multi-link suspension is orthogonal—i.e., it is possible to alter one parameter in the suspension at a time without affecting anything else.
A linkage between these hubs pivots the two wheels together, and by careful arrangement of the linkage dimensions the Ackermann geometry could be approximated. This was achieved by making the linkage not a simple parallelogram, but by making the length of the track rod (the moving link between the hubs) shorter than that of the axle, so that ...