Ad
related to: bunsen burner set up diagram
Search results
Results From The WOW.Com Content Network
The gap, set by the distance between the nut and the end of the tube, regulates the influx of the air in a way similar to the open slots of the Bunsen burner. The Teclu burner provides better mixing of air and fuel and can achieve higher flame temperatures than the Bunsen burner. [9] [10]
A Büchner flask, also known as a vacuum flask, [1] filter flask, suction flask, side-arm flask, or Bunsen flask, is a thick-walled Erlenmeyer flask with a short glass tube and hose barb protruding about an inch from its neck.
A 5-inch (125 mm) square of wire gauze with ceramic center Using wire gauze with an alcohol burner Wire gauze or wire mesh is a gauze woven of metal wire, or very fine, gauze-like wire netting. Wire gauze is placed on the support ring that is attached to the retort stand between a burner and glassware , or is placed on a tripod to support ...
A pipeclay triangle is a piece of laboratory apparatus that is used to support a crucible being heated by a Bunsen burner or other heat source. It is made of wires strung in an equilateral triangle on which are strung hollow ceramic, normally fire clay, tubes. The triangle is usually supported on a tripod or iron ring.
The fishtail burner was similar to the flat burner, but it produced a brighter flame and conducted less heat. The last burner that was experimented with was the Welsbach burner. Around this time the Bunsen burner was in use along with some forms of electricity. The Welsbach was based on the idea of the Bunsen burner, still using gas.
Bunsen burner flames with different oxygen levels: 1. diffusion flame, 2. reducing flame, 3. fuel-rich neutral flame, 4. neutral flame. Oxygen rich butane torch flame.
Today the same principle applies with outdoor patio heaters or "mushroom heaters" which act as giant Bunsen burners. Modern gas heaters have been further developed to include units that utilize radiant heat technology, rather than the principles of the Bunsen burner. This form of technology does not spread via convection, but rather, is ...
Flame temperatures of up to 1,100–1,200 °C (2,000–2,200 °F) are achievable. Compared with a Bunsen burner, the lower part of its tube has more openings with larger total cross-section, admitting more air and facilitating better mixing of air and gaseous fuel.