Search results
Results From The WOW.Com Content Network
The gaseous state of water is lighter than air (density 0.804 g/L at STP, average molecular mass 18.015 g/mol) due to water's low molar mass when compared with typical atmospheric gases such as nitrogen gas (N 2). It is non-flammable and much cheaper than helium.
Highly Toxic: a gas that has a LC 50 in air of 200 ppm or less. [2] NFPA 704: Materials that, under emergency conditions, can cause serious or permanent injury are given a Health Hazard rating of 3. Their acute inhalation toxicity corresponds to those vapors or gases having LC 50 values greater than 1,000 ppm but less than or equal to 3,000 ppm ...
This list is sorted by boiling point of gases in ascending order, but can be sorted on different values. "sub" and "triple" refer to the sublimation point and the triple point, which are given in the case of a substance that sublimes at 1 atm; "dec" refers to decomposition. "~" means approximately. Blue type items have an article available by ...
The official density of water at 60 °F according to the 2008 edition of ASTM D1250 is 999.016 kg/m 3. [2] The 1980 value is 999.012 kg/m 3 . [ 3 ] In some cases the standard conditions may be 15 °C (59 °F) and not 60 °F (15.56 °C), in which case a different value for the water density would be appropriate ( see standard conditions for ...
Consequently, if a liquid has dynamic viscosity of n centiPoise, and its density is not too different from that of water, then its kinematic viscosity is around n centiStokes. For gas, the dynamic viscosity is usually in the range of 10 to 20 microPascal-seconds, or 0.01 to 0.02 centiPoise. The density is usually on the order of 0.5 to 5 kg/m^3.
The term inert gas is context-dependent because several of the inert gases, including nitrogen and carbon dioxide, can be made to react under certain conditions. [1] [2] Purified argon gas is the most commonly used inert gas due to its high natural abundance (78.3% N 2, 1% Ar in air) [3] and low relative cost.
It is a toxic, corrosive, colorless gas, with a density of about 13 kg/m 3 (22 lb/cu yd) (roughly 11 times heavier than air). [2] [3] It is the densest known gas under standard ambient temperature and pressure (298 K, 1 atm). [4] WF 6 is commonly used by the semiconductor industry to form tungsten films, through the process of chemical vapor ...
Drip gas, so named because it can be drawn off the bottom of small chambers (called drips) sometimes installed in pipelines from gas wells, is another name for natural-gas condensate, a naturally occurring form of gasoline obtained as a byproduct of natural gas extraction. It is also known as "condensate", "natural gasoline", "casing head gas ...