When.com Web Search

  1. Ads

    related to: remove rusty nut from bolt top hole on kenmore washing machine

Search results

  1. Results From The WOW.Com Content Network
  2. Wig wag (washing machines) - Wikipedia

    en.wikipedia.org/wiki/Wig_wag_(washing_machines)

    The wig-wag is the common name for the unusual solenoid mechanism used in belt-drive washing machines made by Whirlpool, Kenmore (manufactured by Whirlpool) and others, from approximately 1950 to 1987 in the United States. [1] It was used in belt-drive Brastemp and Consul models built in Brazil from 1959 to 1990.

  3. Nut (hardware) - Wikipedia

    en.wikipedia.org/wiki/Nut_(hardware)

    Sex bolt: Barrel nut, barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt Has a barrel-shaped flange and protruding boss that is internally threaded Split nut: Split lengthwise into two pieces (opposed halves) so that its female thread may be opened and closed over the male thread of a bolt or leadscrew Sleeve nut ...

  4. Washer (hardware) - Wikipedia

    en.wikipedia.org/wiki/Washer_(hardware)

    Spherical washer nut and screw Part of a self-aligning nut; it is a washer with one radiused surface, which is designed to be used in conjunction with a mating nut in order to allow for up to several degrees of misalignment between parts. [4] Anchor plate or wall washer A large plate or washer connected to a tie rod or bolt.

  5. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    A machine screw is generally a smaller fastener (less than 1 ⁄ 4 inch (6.35 mm) in diameter) threaded the entire length of its shank that usually has a recessed drive type (slotted, Phillips, etc.). Machine screws are also made with socket heads (see above), in which case they may be referred to as socket head machine screws. stove bolt ...

  6. Bolt (fastener) - Wikipedia

    en.wikipedia.org/wiki/Bolt_(fastener)

    Bolts use a wide variety of head designs, as do screws. These are designed to engage with the tool used to tighten them. Some bolt heads instead lock the bolt in place, so that it does not move and a tool is only needed for the nut end. Common bolt heads include hex, slotted hex washer, and socket cap.

  7. Distorted thread locknut - Wikipedia

    en.wikipedia.org/wiki/Distorted_thread_locknut

    A distorted thread locknut, [1] is a type of locknut that uses a deformed section of thread to keep the nut from loosening due to vibrations, or rotation of the clamped item. There are four types: elliptical offset nuts, centerlock nuts, toplock nuts and partially depitched (Philidas) nuts.