Ads
related to: cord covers stick on brick black exterior wall sheathing instructions chartamazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
Cordwood masonry wall detail. The method is sometimes called stackwall because the effect resembles a stack of cordwood. A section of a cordwood home. Cordwood construction (also called cordwood masonry or cordwood building, alternatively stackwall or stovewood particularly in Canada) is a term used for a natural building method in which short logs are piled crosswise to build a wall, using ...
Parachute cord (also paracord or 550 cord when referring to type-III paracord) is a lightweight nylon kernmantle rope originally used in the suspension lines of parachutes. This cord is useful for many other tasks and is now used as a general purpose utility cord by both military personnel and civilians.
Magnesium oxide wallboard (10 mm thickness) Magnesium oxide, more commonly called magnesia, is a mineral that when used as part of a cement mixture and cast into thin cement panels under proper curing procedures and practices can be used in residential and commercial building construction.
Housewrap is installed between the sheathing and the exterior siding, and is used behind vinyl, wood clapboards, shingles or shakes, brick, and other building materials. In all cases, the housewrap helps prevent water intrusion when moisture in any form gets past the siding and its trim and caulking.
The rainscreen in a wall is sometimes defined as the first layer of material on the wall, the siding itself. [2] Also, rainscreen is defined as the entire system of the siding, drainage plane and a moisture/air barrier. [5] [6] A veneer that does not stand off from the wall sheathing to create a cavity is not a rainscreen.
A typical timber shear wall consists of braced panels in the wall line, constructed using structural plywood sheathing, specific nailing at the edges, and supporting framing. A shear wall is an element of a structurally engineered system that is designed to resist in- plane lateral forces, typically wind and seismic loads.
Tuckpointing was a way of achieving a similar effect using cheap, unrubbed bricks; these were laid in a mortar of a matching colour (initially red, but later, blue-black bricks and mortar were occasionally used) and a fine fillet of white material, usually pipe clay or putty, pushed into the joints before the mortar set. [4]
The outer jacket is labeled with letters that show how many insulated wires are concealed within the sheath. This does not include the uninsulated ground wire. For instance, if the cable lists "12-2 AWG", it means there are two insulated 12-gauge wires (a black and a white wire), plus a ground wire.