Ads
related to: polypropylene bulkhead tank fitting with strainer and drain line home depot
Search results
Results From The WOW.Com Content Network
Tank connectors are a type of tank fitting also known as tank inlets, tank outlets, or tank nipples. This fitting must be leakage proof, as the water supply (inward and outward) depends on same. Many different varieties of tank connectors exist. Tank connectors are widely made of plastic or brass. They have a flange either on the edge of one ...
A typical storage tank made of FRP has an inlet, an outlet, a vent, an access port, a drain, and an overflow nozzle. However, there are other features that can be included in the tank. Ladders on the outside allow for easy access to the roof for loading. The vessel must be designed to withstand the load of someone standing on these ladders, and ...
If there is a removable strainer device that fits into the fixed strainer, it is termed a strainer basket. The initial pipe that leads from the strainer to the trap is termed the tailpiece. Floor-mounted water closets seal to the toilet flange of the drain pipe by means of a wax ring. These are traditionally made out of beeswax.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
Polypropylene fittings for solvent welding. A solvent is applied to PVC, CPVC, ABS or other plastic piping to partially dissolve and fuse the adjacent surfaces of piping and fitting. Solvent welding is usually used with a sleeve-type joint to connect pipe and fittings made of the same (or compatible) material.
Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.