Ads
related to: mortise and tenon parts diagram chart
Search results
Results From The WOW.Com Content Network
There are many variations of this type of joint, and the basic mortise and tenon has two components: the mortise hole, and; the tenon tongue. The tenon, formed on the end of a member generally referred to as a rail, fits into a square or rectangular hole cut into the other, corresponding member. The tenon is cut to fit the mortise hole exactly.
The parts included in the typical US mortise lock installation are the lock body (the part installed inside the mortise cut-out in the door); the lock trim (which may be selected from any number of designs of doorknobs, levers, handle sets and pulls); a strike plate (or box keep), which lines and reinforces the cavity in the door jamb or frame ...
The mortise is increased in size to receive a pair of folding wedges each side of the tenon. The hammer-headed key is used where there is no straight member to form the tenon. It is difficult to form a strong tenon on curved cut timber as the short grain there will weaken it, so two mortise sockets are formed one in each piece and a separate ...
A Phoenician joint (Latin: coagmenta punicana) is a locked mortise and tenon wood joinery technique used in shipbuilding to fasten watercraft hulls.The locked (or pegged) mortise and tenon technique consists of cutting a mortise, or socket, into the edges of two planks and fastening them together with a rectangular wooden knob.
You are free: to share – to copy, distribute and transmit the work; to remix – to adapt the work; Under the following conditions: attribution – You must give appropriate credit, provide a link to the license, and indicate if changes were made.
Frames can be constructed by several methods: cope and stick, mortise and tenon, bridle joint, or a simple butt joint. Cope and stick is the most common method, as it is more efficient to manufacture. Mortise and tenon is the strongest, and is often used for large doors which will have greater stresses imposed.
A more recent innovation is the horizontal mortiser, which incorporates a router mounted statically on its side with the workpiece clamped to a multi-axis sliding table. . This type of mortiser can produce either traditional mortise and tenon pairs, however it excels at floating (or 'loose') te
Each plunge creates a mortise that is sized to accept a standard 'DOMINO' loose tenon with an oval-shaped cross section. The original tool supported cutter sizes from 4 mm to 10 mm with available tenon sizes from 4x20 mm up to 10x50 mm. This allowed joints in stock as thin as 10 millimetres (0.39 in).