Search results
Results From The WOW.Com Content Network
A buffer solution is a solution where the pH does not change significantly on dilution or if an acid or base is added at constant temperature. [1] Its pH changes very little when a small amount of strong acid or base is added to it. Buffer solutions are used as a means of keeping pH at a nearly constant value in a wide variety of chemical ...
McIlvaine buffer is a buffer solution composed of citric acid and disodium hydrogen phosphate, also known as citrate-phosphate buffer. It was introduced in 1921 by the United States agronomist Theodore Clinton McIlvaine (1875–1959) from West Virginia University , and it can be prepared in pH 2.2 to 8 by mixing two stock solutions.
There are many different ways to prepare PBS solutions, common ones are Dulbecco's phosphate-buffered saline (DPBS) [2] and the Cold Spring Harbor protocol. [3] Some formulations of DPBS do not contain potassium and magnesium, while other ones contain calcium and/or magnesium (depending on whether or not the buffer is used on live or fixed tissue: the latter does not require CaCl 2 or MgCl 2).
Tyrode's solution is a solution that is roughly isotonic with interstitial fluid and used in physiological experiments and tissue culture. It resembles lactated Ringer's solution , but contains magnesium , a sugar (usually glucose ) as an energy source and uses bicarbonate and phosphate as a buffer instead of lactate .
[1] [2] [3] Most of the buffers were new zwitterionic compounds prepared and tested by Good and coworkers for the first time, though some (MES, ADA, BES, Bicine) were known compounds previously overlooked by biologists. Before Good's work, few hydrogen ion buffers between pH 6 and 8 had been accessible to biologists, and very inappropriate ...
1 mM EDTA, bring to pH 8.0 with NaOH; TE buffer is also known as T 10 E 1 buffer, which can be read as "T ten E one buffer". To make a 100 ml solution of T 10 E 1 buffer, 1 ml of 1 M Tris base (pH 10–11) and 0.2 ml EDTA (0.5 M) are mixed and made up with double distilled water up to 100ml. Add microliter amounts of high molarity HCl to lower ...
[1] Universal buffers consist of mixtures of acids of diminishing strength (increasing p K a ), so that the change in pH is approximately proportional to the amount of alkali added. It consists of a mixture of 0.04 M boric acid , 0.04 M phosphoric acid and 0.04 M acetic acid that has been titrated to the desired pH with 0.2 M sodium hydroxide .
TAE buffer is commonly prepared as a 50× stock solution for laboratory use. A 50× stock solution can be prepared by dissolving 242 g Tris base in water, adding 57.1 ml glacial acetic acid, and 100 ml of 500 mM EDTA (pH 8.0) solution, and bringing the final volume up to 1 litre.