Ads
related to: micro usb 3.0 connector ends with 1amazon.com has been visited by 1M+ users in the past month
Search results
Results From The WOW.Com Content Network
USB 1.0, 1.1, and 2.0 use two wires for power (V BUS and GND) and two wires for one differential signal of serial data. [7] Mini and micro connectors have their GND connections moved from pin #4 to pin #5, while their pin #4 serves as an ID pin for the On-The-Go host/client identification. [8]
USB 3.0 also introduced a new Micro-B cable plug, which consists of a standard USB 1.x/2.0 Micro-B cable plug, with an additional 5-pin plug "stacked" beside it. That way, the USB 3.0 Micro-B host receptacle preserves its backward compatibility with the USB 1.x/2.0 Micro-B cable plug, allowing devices with USB 3.0 Micro-B ports to run at USB 2. ...
Few USB devices made it to the market until USB 1.1 was released in August 1998. USB 1.1 was the earliest revision that was widely adopted and led to what Microsoft designated the "Legacy-free PC". [25] [26] [27] Neither USB 1.0 nor 1.1 specified a design for any connector smaller than the standard type A or type B.
High-speed devices must also be capable of falling-back to full-speed as well, making high-speed devices backward compatible with USB 1.1 hosts. Connectors are identical for USB 2.0 and USB 1.x. SuperSpeed (SS) rate of 5.0 Gbit/s. The written USB 3.0 specification was released by Intel and its partners in August 2008.
An OTG cable has a micro-A plug on one end, and a micro-B plug on the other end (it cannot have two plugs of the same type). OTG adds a fifth pin to the standard USB connector, called the ID-pin; the micro-A plug has the ID pin grounded, while the ID in the micro-B plug is floating.
The USB port is fully compatible with USB 5 Gbit/s (USB 3.0), USB 480 Mbit/s (USB 2.0) and USB 12 Mbit/s (1.1); USB 3.0 devices are compatible, but will operate at USB 2.0 speed if internal USB 3.0 connector is not connected.