Search results
Results From The WOW.Com Content Network
When talking about circuit bit rates, people will interchangeably use the terms throughput, bandwidth and speed, and refer to a circuit as being a '64 k' circuit, or a '2 meg' circuit — meaning 64 kbit/s or 2 Mbit/s (see also the List of connection bandwidths). However, a '64 k' circuit will not transmit a '64 k' file in one second.
The bit time has nothing to do with the time it takes for a bit to travel on the network medium but has to do with the internals of the NIC. To calculate the bit time at which a NIC ejects bits, use the following: bit time = 1 / NIC speed To calculate the bit time for a 10 Mbit/s NIC, use the formula as follows:
The ratio of actual propagation speed to the speed of light is also called the velocity factor of the medium. The propagation delay of a physical link can be calculated by dividing the distance (the length of the medium) in meter by its propagation speed in m/s. Propagation time = Distance / propagation speed
OC-48 is also used as a transmission speed for tributaries from OC-192 nodes in order to optimize card slot utilization where lower speed deployments are used. Slower cards that drop to OC-12, OC-3 or STS-1 speeds are more commonly found on OC-48 terminals, where use of these cards on an OC-192 terminal would not allow for full use of the ...
In a network simulation model with infinite packet queues, the asymptotic throughput occurs when the latency (the packet queuing time) goes to infinity, while if the packet queues are limited, or the network is a multi-drop network with many sources, and collisions may occur, the packet-dropping rate approaches 100%.
The speed of light imposes a minimum propagation time on all electromagnetic signals. It is not possible to reduce the latency below = / where s is the distance and c m is the speed of light in the medium (roughly 200,000 km/s for most fiber or electrical media, depending on their velocity factor).
In data communications, the bandwidth-delay product is the product of a data link's capacity (in bits per second) and its round-trip delay time (in seconds). [1] The result, an amount of data measured in bits (or bytes), is equivalent to the maximum amount of data on the network circuit at any given time, i.e., data that has been transmitted but not yet acknowledged.
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.