Search results
Results From The WOW.Com Content Network
A hydrostatic test involves pressurising the cylinder to its test pressure (usually 5/3 or 3/2 of the working pressure) and measuring its volume before and after the test. A permanent increase in volume above the tolerated level means the cylinder fails the test and must be permanently removed from service. [3]: sect. 5.7.3
A hydrostatic test is a way in which pressure vessels such as pipelines, plumbing, gas cylinders, boilers and fuel tanks can be tested for strength and leaks. The test involves filling the vessel or pipe system with a liquid, usually water, which may be dyed to aid in visual leak detection , and pressurization of the vessel to the specified ...
Activated sludge tank at Beckton sewage treatment plant, UK.The white bubbles are due to the diffused air aeration system. The activated sludge process is a type of biological wastewater treatment process for treating sewage or industrial wastewaters using aeration and a biological floc composed of bacteria and protozoa.
A percolation test (colloquially called a perc test) is a test to determine the water absorption rate of soil (that is, its capacity for percolation) in preparation for the building of a septic drain field (leach field) or infiltration basin. [1] The results of a percolation test are required to design a septic system properly.
TSS of a water or wastewater sample is determined by pouring a carefully measured volume of water (typically one litre; but less if the particulate density is high, or as much as two or three litres for very clean water) through a pre-weighed filter of a specified pore size, then weighing the filter again after the drying process that removes all water on the filter.
The lake retention time for a body of water with the volume 2,000 m 3 (71,000 cu ft) and the exit flow of 100 m 3 /h (3,500 cu ft/h) is 20 hours.. Lake retention time (also called the residence time of lake water, or the water age or flushing time) is a calculated quantity expressing the mean time that water (or some dissolved substance) spends in a particular lake.
The most common test involves measuring the flow of water flowing out of a municipal fire hydrant (measured in litres or gallons per minute) while recording how much the water pressure has dropped (from no water flow to test flow). When the results are collected carefully, formulas can be applied to figure the varying pressure(s) that will be ...
Imhoff tank. a - upper chamber, b-c - outlet for sludge, d - outlet for biogas (would need to be higher), f - lower chamber, g - slot for sludge to pass from the upper to the lower chamber, h - height. The Imhoff tank, named for German engineer Karl Imhoff (1876–1965), is a chamber suitable for the reception and processing of sewage.