Ads
related to: t nut dimension chart guitar scale length measured pictures printable
Search results
Results From The WOW.Com Content Network
Fender has also built some 3/4-size student guitars with a scale length of 22.5 inches (570 mm) or shorter. Gibson uses a scale length of 24 + 3 ⁄ 4 inches (630 mm) on most of its electric guitars, including the ES-335, Les Paul, SG, Flying V, and Explorer. Gibson has used other scale lengths on various models through the years.
Scale: 24.75" Woods; Body: Mahogany: Neck: Mahogany and Walnut: Fretboard: Rosewood or Ebony with trapezoid, block, or dot mother of pearl inlays: Hardware; Bridge: Tune-o-matic ABR-1 style, after 2008 Nashville style: Pickup(s) 1, 2 or 3 Firebird Pickups, Full Size Humbuckers, or P-90s: Colors available
The Yamaha GL-1 is a guitalele, also known as a 1/4 size guitar or guitar-ukulele hybrid, combining the size of an ukulele with the wider fretboard and six single nylon strings of a classical guitar. The guitalele combines the portability of an ukulele, due to its small size, with greater chord possibilities from six strings.
The bending stress on the neck is considerable, particularly when heavier gauge strings are used. The most common scale length for classical guitar is 650mm (calculated by measuring the distance between the end of the nut and the center of the 12th fret, then doubling that measurement). However, scale lengths may vary from 635-664mm or more. [51]
A multi-scale fingerboard or fretboard is typically based on two scale lengths, but could potentially incorporate more. The most typical use is one (long) scale length for the low string and a different, usually shorter, scale for the highest string. This could be achieved by angling the nut, and bridge, and fanning the frets. Strings between ...
In addition to the thinline body, another feature of the Gibson ES-350T is its shortened length of only 597 mm (23 1 ⁄ 2 inch compared to Gibson's standard 24 3/4 inch). It has been stated that this short scale is due to the jazz guitarist Tal Farlow, who had expressed the desire to make difficult chords and melodies easier to grasp. [ 1 ]
Both have 12 frets clear of body, 25 in (640 mm) scale length. Later models may have mahogany back and sides, or even mahogany tops. The L-1 model was discontinued in 1937. L-0 was discontinued in 1933, re-introduced in 1937, and finally discontinued in 1942. Before 1929, [3] L-1, L-0 are 13 + 1 ⁄ 2 in (340 mm) wide with a round bottom shape.
T-nuts. The left one has been inserted in the wood and a bolt has been screwed in from the other side. A T-nut, T nut, or tee nut (also known as a blind nut, [1] which can however also refer to a rivet nut or an insert nut, and likewise drive-in nut [2]) is a type of nut used to fasten a wood, particle or composite materials workpiece, leaving a flush surface.