Ads
related to: low noise transistor array amplifier for salesweetwater.com has been visited by 100K+ users in the past month
Search results
Results From The WOW.Com Content Network
A low-noise amplifier (LNA) is an electronic component that amplifies a very low-power signal without significantly degrading its signal-to-noise ratio (SNR). Any electronic amplifier will increase the power of both the signal and the noise present at its input, but the amplifier will also introduce some additional noise.
The sensors which transimpedance amplifiers are used with usually have more capacitance than an op-amp can handle. The sensor can be modeled as a current source and a capacitor C i. [4] This capacitance across the input terminals of the op-amp, which includes the internal capacitance of the op-amp, introduces a low-pass filter in the feedback path.
Power op-amp with a maximal current output of 3 amperes [23] LM709 Yes General-purpose op-amp [24] LM741 LM709 General-purpose op-amp. [25] Widely used. LM747: Yes General-purpose dual op-amp. [26] LM748 General-purpose op-amp with external compensation [27] LM833 Dual high-speed audio operational amplifiers [28] LM837 Low-noise quadruple op ...
In a single-stage amplifier, one can increase channel length to get higher output resistance and gain as well, but this also increases the parasitic capacitance of transistors, which limits the amplifier bandwidth. The transistor channel length is smaller in modern CMOS technologies, which makes achieving high gain in single-stage amplifiers ...
(This is the reason for the relatively high noise resistance of the EF86 in the above example.) Thus, tubes with low noise at high frequency do not necessarily have low noise in the audio frequency range. For special low-noise audio tubes, the frequency at which 1/f noise takes over is reduced as far as possible, maybe to approximately a ...
FETs in the signal pre-amp were replaced with bipolar transistors (2N3391A). Revision C January 9, 1970 1079–1238 Low noise ("LN") circuitry was added in the signal preamp, reducing DS voltage on the gain reduction FET and keeping the FET within its linear range. The FET feedback circuit was revised to minimize distortion.