Search results
Results From The WOW.Com Content Network
List of free analog and digital electronic circuit simulators, available for Windows, macOS, Linux, and comparing against UC Berkeley SPICE. The following table is split into two groups based on whether it has a graphical visual interface or not.
Examples of digital comparator include the CMOS 4063 and 4585 and the TTL 7485 and 74682. An XNOR gate is a basic comparator, because its output is "1" only if its two input bits are equal. The analog equivalent of digital comparator is the voltage comparator.
NI Multisim (formerly MultiSIM) is an electronic schematic capture and simulation program which is part of a suite of circuit design programs, [1] along with NI Ultiboard. Multisim is one of the few circuit design programs to employ the original Berkeley SPICE based software simulation. [ 2 ]
The reason to add an amplifier is twofold: it amplifies the voltage difference. It, therefore, suppresses the comparator offset and the kick-back noise of the comparator towards the reference ladder is also strongly suppressed. Typically designs from 4-bit up to 6-bit and sometimes 7-bit are produced.
The comparator circuit value problem (CCVP) is the problem of evaluating a comparator circuit given an encoding of the circuit and the input to the circuit. The complexity class CC is defined as the class of problems logspace reducible to CCVP. [1] An equivalent definition [2] is the class of problems AC 0 reducible to CCVP.
If R 1 is zero (i.e., a short circuit) or R 2 is infinity, the band collapses to zero width, and it behaves as a standard comparator. In contrast with the parallel version, this circuit does not impact on the input source since the source is separated from the voltage divider output by the high op-amp input differential impedance.
The final validity test for the example is to simulate the Chebyshev filter frequency response through the full useful range, which will be taken to be 100 MHz to 5 GHz for this case. This range should permit viewing of the equi-ripple |S12| of the pass band between 0 and -1 dB, somewhat steep stop band |S12| falling off at 1GHz, and an equi ...
In most cases a comparator is implemented using a dedicated comparator IC, but op-amps may be used as an alternative. Comparator diagrams and op-amp diagrams use the same symbols. A simple comparator circuit made using an op-amp without feedback simply heavily amplifies the voltage difference between Vin and VREF and outputs the result as Vout.